Makita BO5030 Technical Information page 7

W
iring diagram
Fig. D-3
BO5031 before
inserting Controller
Connect receptacles
with Brush holders
as illustrated.
Fix lead wires (black)
to Brush holders with
these Lead wire holders.
Route Lead wires (black, white) between
rib A and rib B.
Do not hook any Lead wires to the tops of
the ribs.
Fig. D-4
BO5031 after
inserting Controller
Controller
boss for Tapping screw
Note: Some specifications do not have Noise suppressor.
Fix lead wires (red) for Switch
with these Lead wire holders.
rib A
rib B
rib C
Strain relief
Put the slack portion of Lead wires
(red, white) in the space here.
Fix Lead wire (white) with
Lead wire holders.
Fix Lead wire (red) with Lead
wire holder here.
Put the slack portion of Lead wires
(white) for Noise suppressor in the
space here.
Noise suppressor
Terminal block
Fix Field Lead wire (red) with
the lowest Lead wire holder here.
Fix Controller Lead wire (white)
with Lead wire holder here and
connect Terminal block.
Fix Controller Lead wire (red)
with Lead wire holder here.
Fix Controller Lead wire (red)
with Lead wire holder.
Insert Connector for Lead wire (red) between
rib C and Strain relief, and route the Lead wire (red)
between Strain relief and boss for Tapping screw.
P 7/ 7