Advertisement
Table of Contents
thermOweld
EZ-Lite Remote® Single Shot Adapter Instructions (p/n 38-EZLT-SS)
Follow Single Shot welding instructions included with
mold or follow instructions on the back of this sheet.
Replace step 11 under "Weld
Procedures" with the following;
11. Discard ceramic lid included
with mold. Slide EZ-Lite
Remote® Single Shot Adapter
over mold as shown.
+1 (918) 627-5210 • 1-800-558-1373 • WWW.THERMOWELD.COM
ELECTRICAL GROUNDING • CATHODIC PROTECTION • ELECTRIC UTILITY • RAIL
®
The Contractors Choice
Follow steps 1 thru 10 under "Weld Procedures" for proper
installation of mold onto ground rod and how to place
weld metal into mold.
CR-2, CR-24 & CR-25 WELD TYPES
Follow instruction steps 12 through 14 under "Weld
Procedures on the back of this sheet to complete weld.
Tel. +1.800.558.1373
Tel. +1.918.627.5210
www.thermoweld.com
ECN 2552 REV "A" 03/06/13
34-5657-40
Advertisement
Table of Contents
Summary of Contents for Burndy Continental Industries ThermOweld EZ-Lite Remote 38-EZLT-SS
- Page 1 thermOweld ® The Contractors Choice EZ-Lite Remote® Single Shot Adapter Instructions (p/n 38-EZLT-SS) Follow Single Shot welding instructions included with Follow steps 1 thru 10 under "Weld Procedures" for proper mold or follow instructions on the back of this sheet. installation of mold onto ground rod and how to place weld metal into mold.
- Page 2 GENERAL SAFETY INSTRUCTIONS 1. Weld only items mold is designed for. 2. Do not use worn or broken molds which could cause leakage of molten weld metal. 3. Do not alter molds or accessories without factory authorization. 4. Avoid breathing concentrations of smoke, as it may be hazardous to your health. 5.
Need help?
Do you have a question about the Continental Industries ThermOweld EZ-Lite Remote 38-EZLT-SS and is the answer not in the manual?
Questions and answers