Levoit LV110WP-RF Manual

LV110WP-RF
Pitcher Replacement Filter
Questions or Concerns?
support.eu@levoit.com
S A F E T Y I N F O R M AT I O N
Follow all safety guidelines. Read all instructions before using.
• Only filter tap water. This filter cartridge is not designed to filter
water from other sources (such as river water).
• The filter cartridge may become clogged and may not work
correctly if filtering liquids other than tap water.
• Do not filter hot water (over 35°C / 95°F). This may damage the
filter and may release contaminants.
W A R R A N T Y
Levoit warrants all products to be of the highest quality in material,
craftsmanship and service for a minimum of 2 years, effective from
the date of purchase. Warranty lengths may vary between product
categories. Should you encounter any issues or have any questions
regarding your new product, feel free to contact our helpful Customer
Support Team. Your satisfaction is ours!
1202 N. Miller St., Suite A
Anaheim, CA 92806
USA
Email: support.eu@levoit.com
* Please have your order number ready before contacting customer
support.
Français
Español
Italiano
B E F O R E U S I N G
1. Remove all packaging from the filter
cartridge.
2. Remove the restrictor caps from the
bottom of the filter. [Figure 1.1]
3. Soak the filter cartridge in clean tap Figure 1.1
water (submerged completely) for 15
minutes.
NOTE: There may be carbon dust in the water
while rinsing or soaking the filter. This is normal.
4. Rinse the filter cartridge thoroughly for
10 seconds under running water.
5. Replace the restrictor caps on the
bottom of the filter.
Restrictor Cap Settings Figure 1.2
• Place the restrictor cap in the "+"
position if you want water to filter
faster, or in the "-" position if you want
water to filter more thoroughly.
[Figure 1.2]
• You can remove the caps completely
if you want water to filter as fast as
possible.
Figure 1.3
Rubber Gasket
• Make sure the rubber gasket is
correctly in place on the filter cartridge.
If the rubber gasket has come loose,
press into place, making sure the ridge
is facing up. [Figure 1.3]
6. Place the filter cartridge into the filter
chamber. Press the cartridge into place
Figure 1.4
as firmly as possible to prevent leaks.
[Figure 1.4]
7. Fill the pitcher with cold tap water.
Discard the filtered water. Refill and
discard the water 2 more times.
8. Reset the filter timer by pressing
firmly for 8 seconds. Your filter is ready
to use. [Figure 1.5]
Figure 1.5
A B O U T Y O U R F I LT E R
A. Upper Micro Net
• Removes particles
suspended in the water, such
as sand, rust, sludge, and
organic matter.
B. Activated Carbon
• Uses high-quality activated
+ position
carbon for excellent filtration.
• Removes chlorine taste and
odor effectively.
• Removes pesticides A B C B D
(including Endrin) and
residual pollutants.
– position
• Improves taste of water.
C. Ion-Exchange Resin
• Removes heavy metals (such as lead, cadmium, mercury,
copper, and aluminum).
• Removes minerals from water to soften it, leaving a percentage
of beneficial minerals behind (such as calcium and magnesium).
D. Lower Micro Net
• Final filtration removes any remaining unwanted particles in the
water.