Advertisement
Quick Links
Advertisement
Summary of Contents for Dancover AC08007
- Page 1 Manual for Rope Light Connector 10-02-2014...
- Page 2 Ropelight Connector This manual describes how to connect two sections of rope light together. Important overall safety announcements for rope light Make sure the rope light is used in open areas where air is ventilated and heat can escape to ensure rope light does not overheat.
- Page 3 2. Trim the copper wires from the ends you cut After you have cut the rope light, you will see two wires inside. These wires must be trimmed in order for the connector to correctly be inserted into the rope light. If these wires are not trimmed, the wires may come out and if in touch with each other cause a short circuit.
- Page 4 STEP 3 (NOTICE：When two sections are connected , try to switch it on and check whether the rope light works or not, if the rope lights does not work, simply remove the connector from rope light and turn the rope light or connector 180 degree as to correctly match the positive and negative poles).
- Page 5 Contact information Head office: Dancover A/S For more information Nordre Strandvej 119 G please visit: 3150 Hellebæk www.dancovershop.com Denmark National contact Denmark: Spain: denmark@dancover.com espana@dancover.com Italy: uk@dancover.com italia@dancover.com Germany: Switzerland: germany@dancover.com schweiz@dancover.com France: Austria: france@dancover.com austria@dancover.com Sweden: Norway: sverige@dancover.com norge@dancover.com...
Need help?
Do you have a question about the AC08007 and is the answer not in the manual?
Questions and answers