Advertisement
USERS MANUAL
EBS 802 – REAR PANEL FEATURES
1
1. MAINS
. Connect your power cable to the
mains input.
2. SPEAKER OUTPUTS.
Connect your speakers
here. Minimum load is 2 ohms, which
means you can connect two 4 ohm
speakers at the same time.
Note: The EBS 802 produces 750W RMS @ 2 Ohm.
450 W RMS @ 4 Ohm.
3. TUNER OUT.
This output is taken directly
after the input buffer stage and can be used
to connect to a tuner.
4. EFFECTS LOOP.
This is a serial effects loop
for the use of external units such as box or
rack effects. Nominal level is set for use with
standard stomp boxes. The loop puts the
external effects after the filter, compressor
and drive sections.
w w w . e b s s w e d e n . c o m
3
4
5
9
2
5. REMOTES.
The EBS 802 is equipped with
two remote jacks for controlling the HI
and LO Boost and Filter Active switches,
engage the Drive, as well as a Mute
function with foot switches. The EBS RM-4
footswitch is recommended, but you may
use other footswitch pedals too. Refer to
the rear panel screen print and technical
specification for further info how to connect
your footswitch.
Note: Each of the filter switches on the front panel
needs to be set to inner position in order to be remotely
controlled.
6. BALANCED OUTPUTS.
functions as a high quality line box for
connecting to PA mixing consoles or to
studio or broadcast recording units, with
high noise immunity. The volume level does
not effect these outputs. Use the PRE EQ
output for a clean, unprocessed signal. Use
the POST EQ for a signal processed by
the amps preamp signal. You can use both
outputs at the same time.
7
6
8
A balanced output
EBS 802
10
Advertisement
