Bypass Effects; Effect Parameters - 1010music Fxbox v 2.0 User Manual

Table of Contents

Advertisement

3.
Touch XYPAD in the top middle of the screen to enable the touch control of the two
left parameters. The XYPAD button will be shaded blue and the parameters screen
background will be black when XY control is enabled.
4.
Move your finger left and right to control the top parameter, up and down to control the
bottom parameter. Move right and up to increase the intensity of the effect.
5.
Touch XYPAD again or leave the screen to stop the touch control of the parameters.

Bypass Effects

Fxbox allows you to temporarily bypass or mute individual effects by following these steps:
1.
While on the Main screen, push the Home button to enter bypass mode. The grid cells will be green.
2.
Touch a cell to bypass that effect. The cell will turn red. Touch it again to enable the effect, which will make it
green.
3.
Push the Home button to leave bypass mode. A red bar appears over the names of bypassed or disabled effects.
Figure 16: Bypa ss Sc reen
with FILT Muted
Effect Param eters
The table below describes the parameters for each of the effects.
Label
Effect
BTCR
Bit reduction and
sample rate reduction
CHR
Chorus
DIST
Distortion
DLY
Delay
P. 13
3:54 PM
v. 2.0
Figure 17: Ma in Sc reen
with FILT Muted
Parameter
Settings
Frequency
0 to 100% Determines sampling frequency from 187Hz to
48kHz.
Resolution
0 to 100% Determines output resolution from 1 bit to 24
bits.
Trigger
ON:
the effect is constantly applied.
Gate: effect is triggered via CV input, momentary touch,
MIDI input, or the step sequencer.
Amount
0 to 100% Controls the intensity of the effect.
Trigger
ON:
the effect is constantly applied.
Gate: effect is triggered via CV input, momentary touch,
MIDI input, or the step sequencer.
Distortion
0 to 100% Amount of distortion.
Trigger
ON:
the effect is constantly applied.
Gate: effect is triggered via CV input, momentary touch,
MIDI input, or the step sequencer.
Delay
Determines the delay length specified in musical
intervals. The incoming clock or MIDI clock sets the
tempo for this setting.
Fxbox 2.0 User Manual
Copyright ©1010music LLC 2019
Figure 15: XYP AD
Ena bled
Mod
Target?
Yes
Yes
No
Yes
No
Yes
No
Yes
1/22/19

Advertisement

Table of Contents
loading

Table of Contents