T-Fal Thermo-Spot CB540852 Instructions For Use Manual page 7

Tfal-ThermSpot-2100071623 18/04/12 17:37 Page7
2 - Connection and pre-heating
4
5
6
4 Set the thermostat of the plug-in connector to mini.
Connect the plug-in connector to the pins of the appliance.
If the plug-in connector is incorrectly positioned, the safety
system will prevent the appliance from working.
5 Fully unwind the power cord.
Plug the cord into the grounded wall outlet.
The red light on the plug-in connector will switch ON and
will stay ON as long as the appliance is plugged in.
Make sure that the electric power supply is compatible with
the power rating and voltage indicated on the bottom of
the appliance.
If an extension cord is used: take all necessary precautions
to prevent anyone tripping over an extension cord.
If the power supply cord is damaged, it must be replaced
by the manufacturer or its service agent or a similarly qual-
ified person in order to avoid a hazard.
The power supply cord should be regularly examined for
signs of damage, and if the cord is damaged, the appliance
must not be used.
Never use the appliance when it is empty. On first use, there
may be a slight odor and a little smoke during the first few
minutes. In these cases open the window an wait until
there is no more smoke or odor.
This appliance is not intended to be operated by means of
an external timer or separate remote control system.
6
Pre-heat the appliance for about 10 minutes on position 5
before every use.
Set the thermostat to the desired position.
Once preheated, the Thermo-Spot pattern will become
completely red. This indicates the griddle is ready for use.
Leave to cook depending on your taste.
EN
7