Instructions - AquaScape Pondless 49000 Instructions & Maintenance

Instructions

STEP 1
EXCAVATE BASIN
• It is recommended to lay out the position of the Pondless
Waterfall Vault and AquaBlox prior to excavation to
determine actual excavation dimensions.
• Using a can of brightly colored spray paint, trace around
the vault and AquaBlox to outline the area that is to be
excavated.
• Using the traced area as a guide, dig the hole.
NOTE: An additional 6" of excavation is recommended
per side of the basin to allow for AquaBlox dimensions,
sufficient backfill material, and compaction required during
backfilling.
• See Ex. 1, 2, and 3 for examples of Pondless Waterfall
storage basin configurations. Larger storage basins can
be constructed by increasing the quantity of AquaBlox
Small Water Storage Modules and/or using the optional
Pondless Waterfall Vault Extension in combination with the
AquaBlox Large Water Storage Modules. Liner and
geotextile dimensions will vary according to the quantity
and size of AquaBlox used.
Pondless ® Waterfall Vault location
when using 3 AquaBlox.
• The optional Pondless
Waterfall Vault Extension
(#49001) slides onto the top
of the Pondless Waterfall
Vault, increasing the height
for deeper basins using the
AquaBlox Large. The
extension slides on from the
front of the unit towards the
back (Ex. 2).
NOTE: Check for presence
of high water table in the excavation, which must be a
minimum of 3 feet below the bottom of the AquaBlox
structure at all times.
4
For maximum structural strength on
larger storage basins, locate the vault
between AquaBlox.
Ex. 1
Ex. 2
☎
STEP 2
EXCAVATE LOCATION OF PONDLESS
WATERFALL VAULT
• Excavate a recessed area for the Pondless Waterfall Vault.
This positions the vault at the lowest point in the storage
basin, allowing maximum water availability for the pump
system (Ex. 3).
Pondless Waterfall Vault with Extension
STEP 3
ASSEMBLE AQUABLOX WATER STORAGE MODULES
Step 1: Evenly distribute and connect the small panels to
one large panel.
Step 2: Next, working from one end to the other, attach a
second large panel on the opposite side of the first.
Step 3: Once the top and bottom large panels are attached,
attach the sides of the tank module. This is a
"single" AquaBlox.
SINGLE MODULE ASSEMBLY
Step 1
Step 3
☎
US (866) 877-6637 | CAN (866) 766-3426 | aquascapeinc.com
Pondless Waterfall Vault
Step 2
Ex. 3