Advertisement
Short description
TSS8030R smoke detector is designed for early warning of a fire condition responding to fixed
threshold smoke concentration detected in the protected premises. The smoke sensitivity is factory
preset.
The principle of functioning of the detector is based on infrared rays distraction caused by smoke
particles entering the optic chamber. The fire detector is controlled by a microprocessor, operating
on the basis of improved algorithm for self-compensation of the chamber contamination.
Technical parameters
Supply voltage range
Maximum supply current
Smoke sensitivity
Time to enter Duty mode after power supply is on
Reset time
Time to enter Duty mode after reset
Protected area
Height of mounting
Operating temperature range
Operating humidity
Dimensions
Weight
Cross section of the connecting wire
LED indicators
Both LED indicators (pos.3) allow range of visibility 360° and provide information for the status:
-
Duty mode - the LEDs are not lit;
-
Fire condition - the LEDs produce continuous light;
-
Contaminated chamber- the LEDs flash briefly every 1s.
TSS8030R_R2.2 – October 2018
Smoke detector
resistance
TSS8030R
10 to 30 VDC
18mA/10VDC
55mA/30VDC
complies with
EN 54-7:2000+ A1:2002
up to 40s
2s
up to 40s
circle with diameter 15 m
up to 11 m
-10 to +55 °C
(93 ± 3)% at 40°C
Ø100 mm, h 47mm
0,100 kg
0.8 to 1.5 mm²
Page 1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Teracom TSS8030R
- Page 1 Smoke detector TSS8030R Short description TSS8030R smoke detector is designed for early warning of a fire condition responding to fixed threshold smoke concentration detected in the protected premises. The smoke sensitivity is factory preset. The principle of functioning of the detector is based on infrared rays distraction caused by smoke particles entering the optic chamber.
- Page 2 (fig.1) consists of a printed circuit board and an optic chamber (pos.4), fixed in a plastic body (pos.5). TSS8030R can be used with controllers of series TCW1xx, TCW2XX and TCG1xx which have digital inputs in “dry contact” mode. Fore mode details see user manuals.
- Page 3 It is recommended cable shoes to be used. The fire detector is placed on the base (fig.1,pos.1). It is rotated clockwise until reaching the guiding grooves (fig.1,pos.2). It is rotated until rest (fig.3.1). The slots of the base and the body should match (fig.3.2). Locking of the fire detector (fig.4).
- Page 4 Service schedule It is done by authorized personnel and includes the following activities: 1. Inspection for visible physical damage - monthly 2. Testing in real conditions - monthly 3.* Preventive cleaning of the optic chamber - every 6 months *The fire detector is removed from the base. The body cover (fig.1,pos.6) is removed by rotating to rest anticlockwise.
Need help?
Do you have a question about the TSS8030R and is the answer not in the manual?
Questions and answers