Note; Unpacking The Appliance; Overview Of The Components / Scope Of Delivery; Notes For Use - Profi Care PC-VL 3069 LB Instruction Manual

Unpacking the Appliance

1. Remove the appliance from the package.
2. Remove all packaging material such as films, filler, cable
holders and cardboard.
3. Check the delivery contents for completeness.
4. Should the package contents be incomplete or damages
be found, do not take the appliance into operation. Take it
immediately back to the dealer.

NOTE:

Dust or production residues can be located on the appli-
ance. We recommend to clean the appliance as described
under "Cleaning".
Overview of the Components /
Scope of Delivery
Page 3
1 Hook
2 Fastening hooks
3 Propeller
4 Protection grid
5 Mounting screw M2,5*8 mm with nut
6 Switch housing
7 Stand tubes
8 Tube with tank cap
9 Water tank
10 Humidifier base
11 Stand with cover
Page 4: Assembly Overview
12 M5*18 mm screws (4 ×)
13 Base (Base plate)
14 Metal plate with mounting holes (1 ×)
15 M5 nuts (4 ×)
16 Cover of the stand (2 ×)
17 M6*10 mm screws with nuts
18 Motor
19 Rear protection grid
20 Nut for rear protection grid
21 Attachment screw for propeller
22 Front protection grid
Not Shown:
• Remote control
• ST4*25 mm screw for fastening the humidifier to the
stand
• M6 nuts to fasten the motor to the stand tubes (2 ×)
46
PC-VL3069LB_IM

Notes for Use

• You can use this appliance to increase the air humidity in
a dry environment. This offers the following benefits:
- Provides a healthy indoor environment and is thus
beneficial to your well-being.
- Your skin does not dry out as readily.
- Static in the air is eliminated.
• The appliance works best if doors and windows are kept
closed when used in mist mode.

Electrical Connection

1. Before inserting the plug into the socket. Make sure that
the mains voltage to be used matches that of the appli-
ance. You can find this information on the nameplate.
2. Connect the appliance to a duly installed protective
contact socket. The indicator lamp POWER shows that
the power supply is connected.

Fitting Batteries into the Remote Control

(Batteries not supplied.)
1. Open the lid of the battery compartment on the rear of
the remote control.
2. Insert 2 MICRO batteries of type R03 "AAA" 1.5 V.
3. Please ensure the correct polarity. Details can be found
in the battery compartment.
4. Close the battery compartment.
NOTE:
If you are not going to use the remote control for a
prolonged period, remove the batteries in order to prevent
them from leaking.
CAUTION:
• Used batteries should not be disposed of in the
domestic waste. Please return all batteries to a special
collection point. Your local authority will provide you
with information on this.
• Different types of battery or new and used batteries
must not be used together.

Remote Control Range

The remote control has a range of ca. 8 meters. If this range
becomes shorter, the batteries must be changed.
• To use the remote control, point it at the sensor on the
front of the switch housing.
• Make sure there are no obstacles between the remote
control and the sensor.
• The angle of the remote control to the remote control
sensor should not exceed 30 ° to the right, left, up, and
down.

Position

The ideal position is a non-slip, flat surface.
17.09.19