Samsung DV431AEP User Manual page 20

operating instructions, tips
Digital Graphic
2
Display
Select Cycle
3
Option
Dry Level
4
Selection Button
20_ operating instructions, tips
DV431AEP-03021E_EN_v7.indd 20 DV431AEP-03021E_EN_v7.indd 20
The display window shows the estimated time remaining in the cycle after the
Start/Pause button is pressed. The estimated time remaining may fluctuate as the
cycle progresses. ( )
The Drying light will illuminate and remain lit until the cycle is complete. (
When your dryer is in the cool-down phase, the Cooling light will illuminate. (
When your dryer is in the wrinkle prevent phase, the Wrinkle Prevent light will
illuminate. ( )
When the cycle is complete, "End" will appear in the display panel until the dryer door
is opened or the Power button is pushed. (
If your dryer is paused during a cycle, the indicator lights will blink until the Start/
Pause button is pressed.
Wrinkle Prevent -Wrinkle Prevent provides approximately 180 minutes of
intermittent tumbling in unheated air at the end of the cycle to reduce wrinkling.
Press the Wrinkle Prevent button to activate this feature.
The indicator light above the pad will illuminate when Wrinkle Prevent is selected.
The load is dry, and can be removed at any time during the Wrinkle Prevent cycle.
Mixed Load Bell - This is an alarm that notifies the user when the average dry
level is damp dry (80 % dried). This is useful when the laundry contains various
types of clothing you do not want to dry completely. An alarm sounds for five (5)
seconds while continuing to perform the cycle.
This function can only be selected in the Sensor Dry course, and the dry level can
only be selected from Cupboard Dry to Extra Dry.
Delay End : You can set the dryer to finish your drying cycle automatically at
a later time, choosing a delay of between 4 to 24 hours (in 1 hour increments).
The hour displayed indicates the time at which the dry will be finished. (
1. Manually or automatically set your drying machine according to the type
of laundry you are drying.
2. Press the Delay End button repeatedly until the required delay time is set.
If the delay time is set, the "Delay End" function becomes ON state.
3. Press the Start/Pause button. The "Delay End " indicator will blink and the
clock will begin counting down until it reaches the set time.
4. To cancel a Delay End function, press the Power button and then turn the
dryer on again.
My Cycle : Choose your favorite cycle including cycle, temp, dry level option,
etc. (See page 22 for detail.)
Rack Dry : Rack Dry is available at Time Dry cycle. Temperature will be set
only to Extra Low. (See page 23 for detail.)
Adjust Time – Time can be added or subtracted from the automatically set times
in the Manual Dry cycles (Time Dry, Quick Dry, Air Fluff cycles).
To add or subtract time from the cycle, press the Adjust Time arrow pad up or
down until the desired time is displayed.
To select the dry level in the Sensor Dry cycles, press the Dry Level button. An
indicator light will illuminate next to the desired dryness level.
Press the button repeatedly to scroll through the settings.
)
)
)
)
11/25/2011 12:57:17 AM 11/25/2011 12:57:17 AM