System Setup - Schumacher Electric SA1346 Owner's Manual

System Setup

Plug the display into the car's 12V socket and start the engine.
NOTE: The sensors have been pre-programmed with values
appropriate for most vehicles.
1. High Pressure Value Setting
1. In standby mode, press and hold
enter system set up mode.
2. Display shows "43 psi" (default) high pressure setting.
3. Press ◄ button to enter set up.
4. Press ►to adjust the values, then press ◄ to save setting.
5. One beep indicates the setting is updated.
2. Low Pressure Value Setting
1. In standby mode, press and hold ■ for 3 seconds to
enter system set up mode.
2. Press ►button.
3. Display shows "26 psi" (default) low pressure setting.
4. Press ◄ button to enter set up.
5. Press ►to adjust the values, then press ◄ to save setting.
6. One beep indicates the setting is updated.
3. High Temperature Setting
1. In standby mode, press and hold ■ for 3 seconds to
enter system set up mode.
2. Press ►button twice.
3. Display shows "154" (default) high temperature setting.
4. Press ◄ button to enter set up.
5. Press ►to adjust the values, then press ◄ to save setting.
6. One beep indicates the setting is updated.
4. Psi/Bar Pressure Unit Setting
1. In standby mode, press and hold
enter system set up mode.
2. Press ►button 3 times.
3. Display shows "Psi/Bar" at the same; default unit is blinking.
4. Press ◄ button to select the other unit.
5. One beep indicates the setting is updated.
5. Temperature Unit Setting
1. In standby mode, press ►button and hold for 3 seconds to enter system set up mode.
2. Choose Fahrenheit or Celsius.
6. To restore default factory settings
1. In standby mode, press ◄ button and hold for 3 seconds.
■
for 3 seconds to
■
for 3 seconds to
• 5 •