Chamber BD208 Quick Setup Manual

Model: BD208
** please NOTe: The factory will
have pre-assembled the keg adapter
for use with a pressurized keg. Please
refer to page 6 of the Instruction
Manual for the Pressurized Tapping
System assembly procedure.
There are 2 options for chilling
your keg prior to serving.
Option 1:
Place keg into the Chambrer
Draft Beer Dispenser, turn on and leave
for 24 hours.
Option 2:
Place the keg into your
refrigerator for 10 hours before placing
it into your Chambrer Draft Beer
Dispenser.
(DO NOT put the keg
into your freezer.)
Your Chambrer Draft Beer Dispenser
will keep your 5 liter keg cool for 30
days after opening.
This Draft Beer Dispenser has built-in
temperature sensors that have been
programmed to automatically keep your
beer chilled to 2ºC – 5ºC (37ºF - 42ºF).
Therefore, your beer will automatically
maintain it's ideal serving temperature.
Dual System Draft Beer Dispenser
Quick Set-Up Guide for PreSSUrizeD Kegs
Step One
Place red ring onto the top of the keg.
Pressing down gently until it clicks into
place.
*MaKe sURe Tap Is IN
ClOseD pOsITION
Step Two
Connect keg adapter onto top of the
keg, pushing down until it clicks into
place.
Step Three
Insert blue pin into hole in the top
of the keg and align tabs within red
ring.
Step Four
Slide white ring down over pin. Push
down on blue pin while tightening
white ring. Do not over tighten.
Step Five
Using keg handles carefully lift and
place into the keg cavity of the
dispenser. Close the lid gently.
Your beer is ready to be
served. Cheers!
Please refer to the Instruction Manual
for detailed information regarding
the proper installation, care and
maintenance of your Chambrer Beer
Dispenser.