Table of Contents
Advertisement
Installation, Operation & Maintenance Manual
Fixing
Unpack all the parts!
1. Carefully remove the rear cover from the unit by releasing the two latching clips located at the bottom
of the case.
2. Using the rear cover - mark the screw holes to the wall.
Ensure the wall surface is flat to prevent base distortion.
3. There are two pre-fractured areas for cable entry provided on the inside of the rear cover which may
be cut away as required.
4. After executing the mounting and the connections – replace the rear cover ensuring the two clips are
latched.
5. Make a note of the installation date on the label located on the side of the unit.
Board Overview
Wiring of different circuits shall be separated by means of routing, clamping or barrier!
All wiring is to be installed within flexible tubing to maintain segregation between circuits!
Any damage attempting to remove the circuit board parts may void any warranty!
Any damage to the device whilst installing and making connections may void any warranty!
Rev 3 11-20
CO2-X
5
Advertisement
Table of Contents
