Global MUD DADDY Instruction Manual

How to start

1. Rinse the jug with water before first use
2. Connect the hose to the Jug. There is a connection point on the underside of the jug.
Ensure the hose is pushed all the way on to the protruding nib. (see image) Then secure
the nut over top of the hose. Secure the nut firmly by hand. Do not over tighten. If you
notice any small leaks once the jug is pressured with air, tighten the nut more until any
small leak stops.
3. Repeat the process to connect the hose to the end of the spray brush. It will have a
similar connection nib.

How to use it?

1. Fill the Jug with cold or warm water (do not use boiling water)
2. Insert the pump into the Jug, and screw down the cap. Ensure pump cap is securely
tightened to the jug.
3. Using the pump, apply 15-25 pumps to pressurize the tank. Do not over pressurize.
4. To get water flow, unlock the trigger on the brush, by pressing the trigger and sliding
downwards. (see image)
5. Press and hold the trigger to release water.
6. If you notice that the water exiting the Jug is slowing, apply additional pumps to re-
pressurize the Jug. You may also need to add more water.
MUD DADDY
Instruction Manual