Advertisement
Table of Contents
BY BATH CO
IMPORTANT
• Please unwrap the bath and check it carefully to ensure it has not been damaged in handling or transport, and check that all parts have been supplied.
• Assemble bath on a mat to protect it against damage to bath surface.
• Please do not remove old fixtures before you unpack and inspect the new unit.
Important
• Store the bath in a safe place until you begin installation to avoid damage.
• The bath can be drilled for tap holes as well as being suitable for free standing taps.
• Any installation should be carried our by a qualified tradesman with knowledge of statutory plumbing requirements in your area.
• This product requires a two person lift – use proper lifting techniques.
• This installation guide does not include details of waste connection; final decision about installation of waste connection should be taken by a suitably qualified person.
Do NOT over-tighten the waste as this may cause long term damage to the bath. We recommend to use a torque wrench to tighten the waste.
Everyday Cleaning We recommend a non-abrasive bathroom cleaner.
WARNING
• Never use bleach products, caustic soda and/or ethyl alcohol (for example Lysoform) or other specifically manufactured cleaners. In case of contact, rinse immediately with water.
• Please note that hair dye/colouring or oil based colours may discolour your bath. Avoid using any strong dye or colour in or near your bath.
• When using underfloor heating please take care not to put the heating pipes/mats underneath the bath area. The bath should not sit on a heated floor.
• Bath mat or suction mats must be avoided – might cause damage to the surface over time.
1
2
3
1 - 2
B
Advertisement
Table of Contents
Summary of Contents for BATHCO VCBC 15.B.27819
- Page 1 BY BATH CO IMPORTANT • Please unwrap the bath and check it carefully to ensure it has not been damaged in handling or transport, and check that all parts have been supplied. • Assemble bath on a mat to protect it against damage to bath surface. •...
- Page 2 You can connect the drain pipe to the waste. You can connect to it with a flexible drain pipe which enables you to tilt the bath up and move the bath into the required position. To avoid water retention in the trap the flexible pipe should have a continuous downward flow.
Need help?
Do you have a question about the VCBC 15.B.27819 and is the answer not in the manual?
Questions and answers