SCHNERZINGER GIGA PROTECTOR Quick Start Manual
  1. Manuals
  2. Brands
  3. SCHNERZINGER Manuals
  4. Receiver
  5. GIGA PROTECTOR
  6. Quick start manual

SCHNERZINGER GIGA PROTECTOR Quick Start Manual

Hide thumbs
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GIGA PROTECTOR and is the answer not in the manual?

Questions and answers

Related Manuals for SCHNERZINGER GIGA PROTECTOR

Summary of Contents for SCHNERZINGER GIGA PROTECTOR

  • Page 1 GIGA PROTECTOR...
  • Page 2 In case of malfunctions contact your SCHNERZINGER dealer. Please do not attempt to service the device yourself or to open it, Connecting the GIGA PROTECTOR to the power grid in that case you will lose your entitlement for our manufacturer Optimal Positioning warranty.
  • Page 3 The GIGA PROTECTOR can be specifically configured so that beside the adjustment to the respective room situation even particular frequency areas can be triggered to allow for direct sound correction in the high-, mid- and low frequency area.
  • Page 4 EMI PROTECTOR, GIGA PICCOLO PROTECTOR, GIGA GUARD, GIGA PROTECTOR If you add your device to an already existing SCHNERZINGER chain, outstanding results will be obtained mostly when all devices will keep their former settings and just the additional product will be installed and configured as described in its manual.
  • Page 5 Optimal Positioning The placement of both GIGA PROTECTOR devices within the room is particularly important. For maximum impact Schnerzinger recommends to test different variants. Recommended placement, in descending order: diagonal front right (beside or behind the speaker) and rear left, or...
  • Page 6 Setting up the GIGA PROTECTOR The GIGA PROTECTOR has an additional GIGA-PULSE amplifier and two functional circuits, allowing to optimally calibrate the unit to the respective interference field spectrum of the environment (e. g. WLAN, mobile communication, DECT, Bluetooth, radio waves and other interfering sources).
  • Page 7 Setting up the GIGA PROTECTOR 3. Step: Switches left: If the bandwidth is to low, the best possible effect will not be reached yet. If the bandwidth is to high, even a sound Functional circuit I – setting the GIGA-PULSE HF-bandwidth degradation may occur.
  • Page 8 If the GIGA PROTECTOR is switched off for a short time only, it still takes effect because of the buffering of the power supply unit. Disconnect the 12V power supply and the CONTROL UNIT from the power grid and the GIGA PROTECTOR resp. Additionally bend the antenna at the hinge into a horizontal position and place the unit on the floor.

Table of Contents