Control-Displays - Major Maxi 4 PSU Manual

Control-displays

The Maxi PSU has 2 control LEDs, which are situated on the same side as the
sockets:
The red LED shining permanent indicates that the 24 V DC supply is OK.
When the "termination"-switch is activated, the red LED is flashing.
The green LED indicates that a DMX signal is present at the XLR5pol. input.
The Micro PSU has three LEDs:
The yellow LED indicates that the "termination"-switch is activated.
The red LED shows, if the 24 V DC supply is OK.
The green LED indicates that a DMX signal is present at the XLR5pol. input.
6 Version: 2.0, 18.11.2011