Page 1
GD12 HP GARBAGE DISPOSER INSTALLATION & USER INSTRUCTIONS If you are replacing an existing dis- poser, continue to Step 2. If there is no existing disposer, disconnect sink drain and skip to Step 9. Invert the disposer and remove the electrical cover plate.
Page 2
Evenly apply a 1/2” thick rope of plumber’s putty (45325) around the new sink flange Using a flathead screwdriver, loosen the 3 from kit SF1. screws on the mounting assembly. Press the new sink flange firmly into the sink drain. Remove the excess plumber’s putty. Using a flathead screwdriver, pry off the snap ring.
Page 3
Using a flathead screwdriver, tighten the 3 screws on the mounting assembly firmly Turn the disposer over against the backup flange. and remove the electrical INSTALL THE MOUNT RING ONTO THE cover plate. NEW DISPOSER. If replacing an old disposer, remove the ex- isting mount ring to be mounted on the new disposer.
Page 5
GD12 HP GARBAGE DISPOSER USER INSTRUCTIONS Basic precautions are always to be followed, including: • Read all instructions before using the appliance. • To reduce the risk of injury, close supervision is required when an appliance is used near children.
GROUNDING INSTRUCTIONS Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualified electrician or serviceman if you are in doubt as to whether the disposer is properly grounded. If the plug provided with the disposer does not fit the outlet, do not modify the plug or attempt to force the plug into the outlet –...