Advertisement
4 MAINTENANCE
4.1
Cleaning
To clean the device, use a soft and dry cloth. Do not use liquids or
abrasive products.
4.2
Battery replacement
To replace the battery:
1.
Open the battery compartment by rotating the cover
counter-clock-wise.
2.
Extract the exhausted battery.
3.
Insert the new battery by paying attention to the polarities.
4.
Close the battery compartment.
WARNING! The exhausted battery is a special waste and it
5 TECHNICAL SPECIFICATIONS
APPLICATION SCOPE
COMMUNICATION
TECHNOLOGY
RANGE IN FREE AIR
POWER SUPPLY
COMMAND ELEMENTS
SIGNAL ELEMENTS
Additional data provided by the manufacturer
USAGE TEMPERATURE
USAGE RELATIVE HUMIDITY
USAGE ENVIRONMENT
SIZES (L x H x w)
Security
Transmission in FM 868.3 MHz
100 m
no. 1 Lithium battery CR2032 3
V
5 keys
5 LEDs: red/green/orange
Low battery
-5 ... + 55 °C
Max 93% max (non-condensing)
Indoor/Outdoor
78 x 40 x 10 mm
2CSYD0301N
shall be disposed according to the regulations in force.
4.3
Reset
WARNING! The reset procedure shall be carried out when
required and only by the installer and not by the user.
To delete the acquisition address and to restore the factory
configuration of the remote control, delete the remote control on the
control unit, remove and re-insert the battery by following the points
1÷4 in the section 4.2.
Package contents
no. 1 Remote control
no. 1 Lithium battery CR2032 3 V (not connected)
no. 1 Manual
WARNING! Installation must be carried out only by a
qualified electrician.
2
EC Declaration of Conformity
ABB S.p.A., with registered office in Milan - via Vittor Pisani 16,
declares under its own responsibility that the device with product
code 2CSYD0301N meets the essential electromagnetic compatibility
and security requirements contained in the Directive R&TTE
1999/5/EC and in the EC Low Voltage Directive 2006/95/CE, as it
was designed and manufactured in compliance with the following
harmonized standards: EN 300 220, EN 50131-1, EN 50131-5-3.
For further information and
ABB S.p.A. –
assistance:
An ABB SACE
Division
Viale dell'Industria, 18
20010 Vittuone (MI)
Printed in Italy
from Monday to Saturday
from 8:00 a.m. to 7:00 p.m.
Manual code 2CSM600508D0201 rev 00
Advertisement
