Walmart Wire Shelving Rack C25B-1 Assembly Instructions

Before returning to your retailer, CALL OUR CUSTOMER SERVICE DEPARTMENT at
1-866-375-7994, 9 a.m. - 5 p.m. EST. MONDAY- FRIDAY or E-Mail: sales@shelfadditions.com

PACKAGE CONTENTS

A - Shelf x 3
E - Pole Cap x 4
Pre-installed on Pole (B)
No tools required for assembly. Helpful - Rubber Mallet
Note: Black plastic discs between shelf collars are for packaging purposes only. They are NOT NEEDED. Discard upon assembly.
SPECIAL WARNINGS
Assemble the item on a soft, non-abrasive surface, such as carpeting, to avoid scratching the finish.
Use care when handling. May require two adults for safe assembly.

CARE AND MAINTENANCE

Periodically check and make sure that all components are in their proper position, are free from damage and that all connectors are tight.

ASSEMBLY INSTRUCTIONS

1. Post Assembly

Screw the two post sections (B) & (C) together. Hands tighten.
Note: the top section has pole connector & cap. The bottom section has insert & feet leveler.
2. Bottom Shelf Assembly
a. Locate the desired position of the bottom shelf. Note: Bottom shelf should be no more than six inches from the floor.
b. Insert two plastic tapered locks (D) in the appropriate pole groove, one set in each pole. Ensure tapered end is up (see arrow on lock).
c. Place shelf (A) on its side and slide each pole with tapered locks through the bottom of the shelf until snug.
d. After all poles are in place, position the unit in the upright position.
e. Push down on each corner of the shelf, ensuring the shelf is in a fully locked position.
3. Additional Shelf Assembly
a. Locate the desired position of the next lowest shelf (A) and insert the tapered locks (D) into the poles.
b. Slide the shelf down from the top of the poles and onto the tapered locks. Push down on each shelf corner, ensuring the shelf is in a fully
locked position.
3 Shelf Wire Shelving Rack
Vendor Stock# C25B-1 / C25Z-1
Assembly Instructions
Questions, Problems, Missing Parts?
B -Top Pole x 4
F – Pole Connector x 4
Pre-installed on Pole (B)
Estimated Assembly Time: Approximately 15 minutes
C - Bottom Pole x 4
G – Screw Pole Insert x 4
Pre-installed on Pole (C)
D - Plastic Tapered Lock x 24 + extra 2
H – Feet Leveler x 4
Pre-installed on Pole (C)