Advertisement
apply the wax directly to the surface of the vehicle. The amount of wax needed will vary according to
the size of the vehicle being waxed. NOTE: Avoid using too much wax.
●
Grip the Polisher/Waxer firmly with both hands. Then turn the Power Switch to its "ON" position and
allow the Pad rotating at speed selector switch position 2-4.
●
Begin applying wax to the vehicle. Apply the wax to all flat surfaces with broad, sweeping strokes in
a criss-cross pattern. Apply the wax evenly over the surface of the vehicle, and add additional wax
as needed.
●
After the wax has been applied to the vehicle's surface, turn the Power Switch to its "OFF" position.
Then unplug the Power Cord. Remove the Waxing Bonnet from the Pad. With the Waxing Bonnet in
your hand apply the wax to all hard to reach areas of the vehicle such as around lights, door handles,
under bumpers, etc.
●
Allow sufficient time for the wax to dry on the vehicle.
●
Place a clean Polishing Bonnet securely onto the Pad.
●
Grip the Polisher/Waxer firmly with both hands. Then turn the Power Switch to its "ON" position and
allow the Pad to rotate to its fullest speed(set the speed selector switch at position 5-6 ).
●
Begin polishing the vehicle by lightly buffing off the wax residue in a circular pattern. Continue polish-
ing until all the wax residue is removed.
●
After the wax has been removed from the vehicle's surface, turn the Power Switch to its "OFF"
position. Then unplug the Power Cord. Remove the Polishing Bonnet from the Pad. With the Polish-
ing Bonnet in your hand, remove the wax from all hard to reach areas of the vehicle such as around
lights, door handles, under bumpers, etc.
4.
SPECIFICATIONS
Power
Voltage
Speed
Pad Size
Cable Length
1.1A
120V~60Hz
1500-3600/min (RPM)
10''
3m
EN
120W
230V~50Hz
25cm
Advertisement
