Table of Contents
Advertisement
Quick Links
Schaberweg 30-34
61348 Bad Homburg
Germany
Power Transmission
Installation and Operating Instruction for
Telephone +49 6172 275-0
Telefax +49 6172 275-275
Irreversible Locks IR
E 08.671e
www.ringspann.com
mailbox@ringspann.com
®
Advertisement
Table of Contents
Summary of Contents for RINGSPANN IR Series
- Page 1 ® Power Transmission Installation and Operating Instruction for Irreversible Locks IR E 08.671e Schaberweg 30-34 Telephone +49 6172 275-0 www.ringspann.com 61348 Bad Homburg Telefax +49 6172 275-275 mailbox@ringspann.com Germany...
- Page 2 Disregarding or misinterpreting these installation and operating instructions invalidates any product liability or warranty by RINGSPANN; the same applies if the product is taken apart or changed. These installation and operating instructions should be kept in a safe place and should accompany the product if it is passed on to others –...
- Page 3 Installation and Operating Instruction E 08.671e for Irreversible Locks IR Issue: 29.04.2013 Version : 2 drawn: Su checked: AB Pages: 6 Page: 3 General introduction Irreversible Locks IR are bidirectional acting roller freewheels with bearing support. The Irreversible Locks IR are used as: ...
- Page 4 It is identified by the suffix „R“ at the end of the product designation. Example: IR 24 R Please note! Further information especially on design, function and selection, permissible torques or permissible speeds of these Irreversible Locks is provided in RINGSPANN Catalog 84 “Freewheels”. Please contact RINGSPANN GmbH if you need assistance.
- Page 5 The maximum permissible freewheel torque must not be exceeded due to torque peaks in specific applications. The maximum freewheel torque should be calculated according to RINGSPANN Catalog 84. Please contact RINGSPANN if you need assistance. Irreversible Locks damage resulting by excessive torque peaks impair...
- Page 6 Installation and Operating Instruction E 08.671e for Irreversible Locks IR Issue: 29.04.2013 Version : 2 drawn: Su checked: AB Pages: 6 Page: 6 Caution! Screws with material grade 12.9 should not be used because of their low breaking elongation. aufs führen! Insert for sizes IR12 and IR24 the bearing disc, made of brass, in the housing (2).
Need help?
Do you have a question about the IR Series and is the answer not in the manual?
Questions and answers