Star2Star Polycom OBi302 Installation Manual

Two-port fxs analog telephone adapter (ata)

Polycom® OBi302

The Polycom® OBi302 is a two-port FXS Analog Telephone Adapter (ATA) device packaged in a compact chassis.

This device can be used for the following purposes:

● Fax machine on FXS port

● Local or remote phone on FXS port

Overview of the Installation Process

The OBi302 is normally pre-configured for use with our StarCloud+ and StarCloud telephone systems. In most

cases, the installer can connect the OBi302 to the customer's network along with the appropriate analog

telephone connections.

The rear panel of the OBi302 has a power connection, USB connection, two RJ11 telephone connectors, and two

RJ45 network connectors, as shown in the following picture:

Communications, LLC. All logos and company names are trademarks or service marks of their respective companies.

A TA Device Installation Guide

OBi302 Rear View

August 2019

Table of Contents

Do you have a question about the Polycom OBi302 and is the answer not in the manual?

Page 1 RJ45 network connectors, as shown in the following picture: OBi302 Rear View August 2019 ® Copyright © 2019, Star2Star Communications , LLC. All rights reserved. Star2Star is a registered trademark of Star2Star Communications, LLC. All logos and company names are trademarks or service marks of their respective companies.
Page 2 Purpose Phone Connections for an FXS (station) device, such as an analog telephone or a fax machine. Not supported in Star2Star configuration. Connection for a laptop computer. Use this connection for off-site configuration. Internet Connection to the local network (if used as a local device) or to a WAN connection (if used as a remote device).
Page 3 A utomatic configuration download only applies to the standard StarBox installation. Configure as a Remote Device The OBi302 can operate as a remote device, but it requires installation-specific configuration information to operate. For assistance, contact Star2Star Technical Support. StarCloud Locations Configure as a Local Device To configure the OBi302 ATA device as a local device: 1.
Page 4 Polycom® OBi302 ATA Device Installation Guide OBi302 Status Lights The following status lights are available on the OBi302 front panel: Light Green Light Indicates Connected to power. Connected to a WAN connection. Connected to a LAN connection. Phone is connected and off-hook. OBi302 Front View Page 4...