Setup; Connecting To The Hub; Configuring The Hub; Calibrating The Hub - Delta Controls O3 Quick Start Guid

Setup

To set up the hub using the O3 Setup app, you must have Bluetooth
location services enabled on your mobile device . For best performance,
your device should support Bluetooth Low Energy (BLE) version 5.0 or
later.

Connecting to the hub

1. Open the O3 Setup app and select Continue to enter Lite Mode.
2. In the lower right corner of the screen, select Connect. Nearby hubs are listed by their Bluetooth MAC address.
3. Select a hub to initiate a connection. Once the connection is initiated, select Verify to confirm that you are
connecting to the correct hub. The selected hub plays a sound and the light ring flashes blue.
4. If this is the correct hub, select Yes, connect to this hub. Data loads from the hub and the status changes to
Connected. You can now view device information and sensor data from the hub in the Diagnostics tab. This
data is transferred securely over Bluetooth from the hub to your mobile device.

Configuring the hub

1. After connecting to the hub, go to Settings > Network. If you want to assign a static IP address to the hub,
select , select Static, enter the IP settings, then select Save. Otherwise, leave it as DHCP. The IP address
must unique for each hub.
2. Next to BACnet, select
BACnet settings, then select Save. The BACnet Device ID must be unique for each hub.
3. Next to Security, select
4. Select Apply settings to hub. After the settings are applied, the status shows Configured and a green check
mark appears next to each applied setting.

Calibrating the hub

1. After connecting to the hub, go to Settings > Calibration and select
2. Measure the temperature below the hub at occupant height, enter the temperature in the Actual temperature
field, then select Save.
3. If you plan to use the hub for lighting control, adjust the lighting in the space to the desired brightness, record
the current hub reading in the Hub reading at desired light level field, then select Save. This setpoint will be
used by the control system as a baseline for control loops to compare against.
4. Select Apply settings to hub.
Upgrading the firmware (requires internet connection)
1. After connecting and applying settings to the hub, in the O3 Setup app, select ⋮ in the upper right corner of the
screen, then select Upgrade firmware.
2. Under Firmware upgrade method, select Select version from list.
3. Select the firmware version you want to upgrade to, then select Apply firmware upgrade.
4. Click OK to continue. The light ring is orange while the upgrade is in progress.
Note: Do not power off or reboot the hub while the light ring is orange. If the light ring flashes red 3 times, there was an error during the
upgrade process. Check your network connections and settings.

Rebooting the hub

To reboot the hub, in the O3 Setup app, select ⋮ in the upper right corner of the screen, then select Reboot hub.
A confirmation appears. To continue, select Yes, reboot hub.
Need help? Contact o3hub@deltacontrols.com
For regulatory and other product information, visit
, select the protocol you want to use (BACnet/Ethernet or BACnet/IP), enter the
, enter a 6-digit PIN to secure BLE read/write access to the hub, then select Save.
support.o3hub.com
and
®
.
View setup videos
Scan QR code with a
mobile device
© 2020 Delta Controls Inc.