Structure & Description - Honeywell PEHA Compact 952 JRM Operating Instruction

STRuCTuRE & DESCRIPTIOn
The compact 952 JRM module allows the convenient control of shutters, blinds, and awnings without user programming. All functions are preprogram-
med and assigned to the inputs and outputs. A function table and wiring diagram can also be consulted for the installation.
L0 O0 O1 O2 O3 O4 O5 L0 O6 O7 O8 O9 O10 O11 L1 L1
µ µ µ µ
µ M0 µ µ M1 µ µ M2 µ M3 M4 µ M5 µ
compact
L N
100-240 V ~
50-60 Hz
Status
12 x 1A
M
100-240V ~ / 50-60Hz
 Bus In  Bus Out
952 JRM
I0 I1 I2 I3 I4 I5 I6 I7 I8 0V I9 I10 I11 I12 I13 I14 I15 I16 I17
The blind/shutter module (JRM) can control 12 servo powered blinds, shutters and awnings. They can be variably assigned to 3 groups (0-2). Manual
operation is performed locally, centrally or in groups using dual buttons. Programmed timers can activate the outputs (motors) at specific times. In
addition, they can be activated by sensors, depending on the level of daylight or the weather. After the power fails, all the blinds/roller shutters are in
an idle state. The top section of the module presents a status LED that flashes green when operating voltage is applied. This status LED emits a steady
red light when the bootloader is active.
O12 O13 O14 O15 O16 O17 L2 L2 O18 O19 O20 O21 O22 O23 L3
µ M6 µ µ M7 µ µ M8 µ µ M9 µ µ M10 µ µ M11 µ
Compact
14:14 17.10.2012
24V
100mA  
PROG
0 24
36 x Input 24V
0V I18 I19 I20 I21 I22 I23 I24 I25 I26 0V I27 I28 I29 I30 I31 I32 I33 I34 I35
L3
9 mm
Illuminated LCD display
PROG,  ,  , EnTER
Device menu
ENTER
and device settings
0V
GB
GB-3