Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Adagio PACIFICA WATERS
Summary of Contents for Adagio PACIFICA WATERS
- Page 1 PACIFICA WATERS COLLECTION Installation Instructions...
- Page 2 Choosing a location Most likely you have already decided on a location for your new Adagio Water Feature. In the event that you are still undecided, we would like to discuss a few things to think about as you make your decision.
- Page 3 A - Unpacking the crate and box Before beginning the installation we suggest unpacking and unwrapping everything. Be sure to set it aside and out of the way to avoid damaging it or hurting yourself. B - Marking the wall Before you begin hanging the brackets you need to mark the wall in a few places.
- Page 4 (1) Using the top center mark, position the wall bracket and mark the slots on the wall. Take extra care to insure the wall bracket is level on the wall. (2) Mount the Bracket. Use the included lead EZ anchors and 1 inch screws to fasten bracket into the sheetrock.
- Page 5 F- Install the water feature on the mounting bracket (1) Hang the Serene Water Feature on the Wall Bracket. Use the clips on the bracket and the square holes on the water feature. Push down gently until the water feature in snug on the clips and hanging level.
- Page 6 H- Adjusting water flow Mirrored Water Features: Sometimes when the glass water surface is dirty the water will not cover properly. First, clean the glass thoroughly. Then, apply a thin coat of the “mirror prep” solution included with your water feature by simply wiping it onto the mirror.
- Page 7 Water Flow: The Water Distribution Unit and Baffle should be set to allow proper water flow. In the event the water does not flow properly please follow the following steps. First, be sure the Water Distribution Unit is clean. Go over surface of the Water Distribution Unit with the included Scotch Brite pad.
- Page 8 Maintenance Filling Water Tray: The biggest maintenance requirement is keeping the water tray full of water. Because of evaporation your water feature will put moisture into the air. The amount of use and the climate will determine how often you need the fill it. Be sure the water level stays at least above the top of the pump and no more than one inch from the top of the tray.
Need help?
Do you have a question about the PACIFICA WATERS and is the answer not in the manual?
Questions and answers