Gree GMV-ND07T/B-T Owner's Manual page 17

(2) Ensure that it's clearance-free between decoration panels and ceiling board after installation,
if not, please adjust the body position.
(3) Connect the decoration panel terminals (Female) to body terminals (Male) as shown in
fig.4.4.3.
4.4.2 Panel Installation
(1) Detach the panel's corner cap, there is a mark "piping side" on one of the 4 corners, adjust
the panel direction so as to keep the mark and fittings on the same corner, as shown in
Fig.4.4.4.
(2) Temporality hang the panel to body (there are four hangers on each corner of the panel,
hang the hangers to corresponding hooks on the body.), as shown in fig.4.4.5.
(3) Detach the air inlet grille from panel, make a wiring connection of signal receiver. Notices
that the connection wire not stuck in the middle of body and panel, or may cause air leakage
and lead to condensation water drop.
(4) Tighten 4 screws at each corner of panel respectively, fix the panel on the body firmly.
(5) After tightening screws, reinstall the air inlet grille.
Multi Variable Air Conditioners Compact Cassette Type Indoor Unit
Fig.4.4.2
Fig.4.4.3
Fig.4.4.4
13