Related Manuals for Fly Products XENIT THOR 250
Summary of Contents for Fly Products XENIT THOR 250
- Page 1 XENIT THOR USER’S MANUAL VERSION - 04/16 FLY Products © s.r.l. Copyright by Via Perù n. 30 63013 GROTTAMMARE (AP) - ITALY tel./fax +39.735.632486 www.flyproducts.com fly@flyproducts.com...
-
Page 2: Section 1. Xenit Thor 250
SPECIFICATIONS Section 1. XENIT THOR 250 The XENIT THOR 250 Trike is for all those pilots who want to fly alone or with a passenger in a light but solid vehicle which is also cost-efficient, low-maintenance and easy to transport. -
Page 3: Section 2. Dimensions
XENIT THOR 250 USER’S MANUAL ____ VER. 1.1 Section 2. DIMENSIONS ___________________________________________________________________________ FLY Products © Copyright s.r.l. Page... -
Page 4: Section 3. Trike Parts
XENIT THOR 250 USER’S MANUAL ____ VER. 1.1 Section 3. TRIKE PARTS ___________________________________________________________________________ FLY Products © Copyright s.r.l. Page... -
Page 5: Section 4. Assembling The Frame
XENIT THOR 250 USER’S MANUAL ____ VER. 1.1 Section 4. ASSEMBLING THE FRAME For easy and correct assembly work through the following steps: Position part N° 1 Remove the belt Lift the back end of the carriage Place the back end of the carriage on a box or any kind of support of about 25 cm high ___________________________________________________________________________ FLY Products © Copyright s.r.l. Page... - Page 6 XENIT THOR 250 USER’S MANUAL ____ VER. 1.1 Insert the support bar (N° 7) Screw the back bolt in place without tightening it Turn the support bar until it is possible to Position the cradle properly and insert the cradle insert the front bolt, tighten both bolts bolts. taking care not to crush the bar. ___________________________________________________________________________ FLY Products © Copyright s.r.l. Page...
- Page 7 XENIT THOR 250 USER’S MANUAL ____ VER. 1.1 Using the nuts, secure the upper and lower bolts. Using the Velcro strips, secure the harness Fit the front belt of the pilot harness. to the lower bar of the carriage. ___________________________________________________________________________ FLY Products © Copyright s.r.l. Page...
- Page 8 XENIT THOR 250 USER’S MANUAL ____ VER. 1.1 Secure belt passenger harness Adjustable belt Pilot harness belt ___________________________________________________________________________ FLY Products © Copyright s.r.l. Page...
- Page 9 XENIT THOR 250 USER’S MANUAL ____ VER. 1.1 Attach the right cable (the one without the Attach the left cable and using the tensioning tensioning device). device pull the cable tight. Insert the push pin from the back into Insert the 2 lower parts of frame. position ___________________________________________________________________________ FLY Products © Copyright s.r.l. Page...
- Page 10 XENIT THOR 250 USER’S MANUAL ____ VER. 1.1 Insert the 2 push pins into position and secure the cage. Insert the upper support and using the push pin secure it in position. ___________________________________________________________________________ FLY Products © Copyright s.r.l. Page...
- Page 11 XENIT THOR 250 USER’S MANUAL ____ VER. 1.1 Assemble the 2 upper parts of the frame and fit them firmly in place using the 6 velcro straps. Attach the 2 ends of the net. Attach the 2 elastic cords near to the wheels. ___________________________________________________________________________ FLY Products © Copyright s.r.l. Page...
- Page 12 XENIT THOR 250 USER’S MANUAL ____ VER. 1.1 Fit the tank into its placement. Connect the fuel tubes. Secure the tank in its placement using the tank belt. ___________________________________________________________________________ FLY Products © Copyright s.r.l. Page...
-
Page 13: Section 5.Mounting The Propeller
XENIT THOR 250 USER’S MANUAL ____ VER. 1.1 Section 5.MOUNTING THE PROPELLER Combine the 2 parts of the propeller. Screw in and tighten the propeller bolts moving across the disc. ___________________________________________________________________________ FLY Products © Copyright s.r.l. Page... - Page 14 XENIT THOR 250 USER’S MANUAL ____ VER. 1.1 The assembled Trike ___________________________________________________________________________ FLY Products © Copyright s.r.l. Page...
-
Page 15: Section 6. Setting Up The Trike For Tandem Or Mono Flight
XENIT THOR 250 USER’S MANUAL ____ VER. 1.1 Section 6. SETTING UP THE TRIKE FOR TANDEM OR MONO FLIGHT Tandem setup The glider attachment must be positioned The glider attachment must be positioned further further back for flights with a pilot of over forward for flights with a pilot of less than 85 kg 90 kg and passenger of less than 85 kg. and passenger of over 90 kg. Mono setup Position the glider attachment as far back as Position the glider attachment as far back as possible and use position 2 for a pilot of possible and use position 1 for a pilot of less than over 90Kg. 85Kg. ___________________________________________________________________________ FLY Products © Copyright s.r.l. Page... -
Page 16: Section 7.Emergency Parachute
XENIT THOR 250 USER’S MANUAL ____ VER. 1.1 Section 7.EMERGENCY PARACHUTE A reserve parachute can be attached to the XENIT THOR 250 and is highly recommended for obvious security reasons. The reserve parachute is located under the harness of the pilot. Assembly procedure of the emergency system: Insert the rescue pack in the pocket, then using a Attach the handle piece of string pull the loop through the hole and close the pocket with the hook ___________________________________________________________________________ FLY Products © Copyright s.r.l. Page... - Page 17 XENIT THOR 250 USER’S MANUAL ____ VER. 1.1 Attach the third hook. Pass the 2 parachute straps through the strap holder Attach the 2 parachute straps to the 2 Side view of the mounted rescue pack and carabiners, protect them with the 2 covers. harness. ___________________________________________________________________________ FLY Products © Copyright s.r.l. Page...
-
Page 18: Section 8. A Assist System
XENIT THOR 250 USER’S MANUAL ____ VER. 1.1 Section 8. A ASSIST SYSTEM Attach the belt to riser A of the glider The belt must not be in tension when the riser A is in vertical position. Section 9. START AND STOPPING ENGINE This trike can be equipped with a manual accelerator Manual accelerator ___________________________________________________________________________ FLY Products © Copyright s.r.l. Page... - Page 19 XENIT THOR 250 USER’S MANUAL ____ VER. 1.1 On startup (when the engine is cold) pull up the Pump the fuel choke (1)Master switch (2) Starter button (3) (RPM gauge-Running time of the engine and water temperature (4) Stop switch ___________________________________________________________________________ FLY Products © Copyright s.r.l. Page...
-
Page 20: Section 10. Specifications
XENIT THOR 250 USER’S MANUAL ____ VER. 1.1 Manual startup (the Polini Thor 250 engine is also equipped with a manual start) Section 10. SPECIFICATIONS Engine type Polini Thor 250 Tank capacity 16 Lt Thrust at sea level 104 kg Propeller 150 cm rz 05 Trike weight when empty 72 kg Max weight transportable (pilot and passenger) 170 kg Tyre pressure 1bar ___________________________________________________________________________ FLY Products ©... - Page 21 XENIT THOR 250 USER’S MANUAL ____ VER. 1.1 Warranty Fly Products (Seller, Our, Us) warrants the original Purchaser that this product shall be free from defects in materials and workmanship under normal use for a period of 12 months from the date of purchase. If for any reason this product is powered by fuel that does not meet the criteria stated in the engine manual, or is used with other equipment, parts or replaceable items (such as consumables) which are neither made nor approved by Fly products, Fly Products shall not be responsible for any loss of quality, degradation of performance or actual damage that results from the use of such fuel, equipment, parts or replaceable items. Seller obligation and liability under this warranty is expressly limited to repairing or replacing, at Seller's option, any product not meeting the specifications. The dealer, from whom you purchased the product, or Fly Products, will repair the product free-of-charge. In no event shall Fly Products be liable to the Purchaser or any other person for any loss or damage whether direct ot indirect or consequential or incidental, including without limitation, any damages or claims by third parties caused by defective products or otherwise arising from the incorrect or otherwise improper use of this product. This warranty applies only to defects in parts and workmanship relating to normal use. It does not cover: • damage arising from improper maintenance or negligence • damage caused by incorrect pilot operation • damage caused by wind or adverse weather conditions • fair wear and tear Fly Products shall, at its option, repair or replace any defective products. Improper use, that is, use for purposes other than those mentioned in this manual will void the warranty. Limited warranty Fly Products shall not be liable to the Purchaser or any other person for damage arising from improper storage, handling or use of this product. Repairs to this Product must be carried out by qualified technicians appointed by Fly Products. This Product must be assembled in accordance with the instructions in this manual. To obtain warranty service, please contact your dealer or Fly Products directly.