Satel SP-4006 Series Installation Manual

OPTICAL-ACOUSTIC
OUTDOOR SIREN
®
SP-4006
sp4006_en_06/09
The SP-4006 optical-acoustic outdoor siren is designed for intruder alarm systems. It comes
in two versions: SP-4006 and SP-4006 BL, which differ by the color of optical signaling (red
in the SP-4006, blue in the SP-4006 BL). As the light source in the siren, two sets of LEDs
are used. The sound signal is generated by means of a piezoelectric transducer. Design of
the siren housing, as well as the inner cover made from galvanized metal sheet, ensure a
high degree of tamper protection (against opening and/or pull-off from the mounting surface).
Electronic circuit is made in SMD technology and impregnated against adverse effect of
weather conditions, thus ensuring a high reliability of the equipment. The outer housing of the
siren is made of PC LEXAN high-impact polycarbonate, so it features a very high mechanical
strength and guarantees esthetic look of the equipment even after many years of service.

1. Installation

Fig. 1. Housing of the SP-4006 outdoor siren.
Explanations for Figure 1:
1 - cover retaining screws.
2 - cable entry hole.
3 - tamper element of the housing (should be screwed to the mounting surface; do not
apply excessive force, so as not to break the narrowings).
4 - mounting holes.
The SP-4006 outdoor siren should be mounted on a flat surface, at a place which is as hard
to access as possible, so as to minimize the risk of tampering. The device must be attached
to the surface by means of screws and expansion plugs. In order to take off the cover,