Learning The Propaq Encore - Propaq Encore 202EL Reference Manual

Learning the Propaq Encore

Using In-Service Mode
You can practice using the Propaq Encore without a patient simulator by using the
Propaq's in-service mode of operation. The in-service mode cannot be activated while you
are monitoring a patient. The message "SIMULATING" alternates with the time of day
and patient mode on the display.
To begin practicing with your Propaq, disconnect all patient cables connected to the
monitor. Leave the cuff connected so you can take NIBP measurements. If you have been
monitoring a patient, turn off the Propaq Encore and turn it back on. From the Main
Menu, press ,
SETUP
The Propaq Encore has two sets of simulated patient information—an initial set and an
alternate set. To change between them, press the
If you connect a patient cable or set the NIBP channel to automatically take pressure
measurements, the Propaq Encore stops simulating, goes through its powerup tests, and
erases any simulated trend data it might have stored.
What You Can Do With In-Service Mode
While using the in-service mode, you can press any of the Propaq Encore buttons, except
for the button in the NIBP Menu, to change a function setting. You can also
AUTO/MAN
• change the ECG and RESP waveform sizes
• set alarm limits and cancel alarms
• STAT SET alarms
• customize the Propaq Encore settings
40
, .
WAVE SEL INSERV
button again.
INSERV
• change from °F to °C
• simulate invasive pressure zeroing
Protocol Systems, Inc.