Page 1
• Use ¼-20x¾” pan-head screws, lockwasher, and washer to bolt hinge-bars to angle. There will be two holes at the bottom and two holes at the top of the angle that will not be used - yet. Page 1 of 4 Gator Kennels Gate-only assembly instructions...
Page 2
• Use ¼-20 x 1” screw and nylock to attach the latch. • The latch should now reach the other hinge-bar. • Adjustments to the hinge-bar may be needed for smooth operation. Page 2 of 4 Gator Kennels Gate-only assembly instructions...
Page 3
• Insert the screw into the hole and tighten the nut. • You can test the safety by trying to lift the entire gate. The screw should stop the gate from lifting. Page 3 of 4 Gator Kennels Gate-only assembly instructions...
Page 4
¼“ Lock ¼“ Flat Pan-head screw Washer Washer 7. Attach the header above the gate. • Use ¼-20 x ¾” Pan-head screws, lockwashers, and flat washers. Enjoy your new kennel gates! Page 4 of 4 Gator Kennels Gate-only assembly instructions...