Traffic Interface Cables; Management Interface Cables; Power Cable - SAF CFM-LM Series Technical Description

C A B L E S

Traffic Interface Cables

The following types of traffic interface cables could be used with CFM-LM IDU traffic interfaces:
•
Cat3 unshielded twisted pair (UTP) or better for 10Base-T Ethernet;
Cat5 UTP or better for 100Base-Tx Ethernet connection;
•
Cat3 UTP or better for the E1 balanced interfaces;
• Any 75 Ω coaxial cable with BNC connectors for the E1 unbalanced traffic port.
For cable connector pinouts please refer to the CFM product configuration guides, see References
for more information.

Management Interface Cables

•
Standard Ethernet patch cables should be used with management Ethernet port of the
IDU;
•
Any "straight through" or modem serial cable could be used with RS-232 management
port of the IDU.

Power Cable

Due to low power consumption of the CFM terminals, there are no special requirements for the
cable used to connect the IDU to the DC power source. Any 2 wire power cable of good quality
which fits well in SAF Tehnika's supplied 2 pole "screw on" power connector could be used. The
power connector is of 2 pole, type 2ESDV-02.
42