Page 2
Charging indicator Mounting arm release light button Phone mounting arm Knob Wireless charger fixing Clip release button clip Charging cable DC Type-C port port Proximity sensor...
Page 3
1. Install the wireless car charger. a. Plug the standard charging cable into the DC port to connect the wireless charger to the cigarette lighter port. b. Press the clip release button on the back of the wireless charger to open the clip c.
Page 4
• Adjust the knob on the back of the wireless charger to secure the wireless charger in place. • To reach the maximum charging power of 27 W, use the standard charging cable and ensure that your phone supports 27 W charging. •...
Page 5
Do not connect all-in-one data cables, such as two-in-one or three-in-one data cables, to the wireless charger. 2. Place your phone (must support Qi wireless charging) near the proximity sensor and the phone mounting arms will open automatically. Place your phone on the wireless charger and the phone mounting arms will automatically attach to your phone.
Page 6
the surface of the wireless charger, as shown in the figures below. Ensure that there are no metallic objects between the surface of the wireless charger and your phone. Avoid using a metallic protective case. If you place a phone that does not support wireless charging on the wireless charger, the charging indicator light will also...
Page 7
flash. 3. Before exiting your car, touch the mounting arm release button on the left side of the wireless charger and remove your phone when the mounting arms open. When the power at the cigarette lighter port or power supply port is cut off, take out your phone directly.
Page 8
The sticker stand cannot be repositioned once it has been attached. Please attach it to an appropriate location in your car.
English Safety Information Before you use the device, read the following precautions carefully to ensure optimal product performance and to avoid danger or violation of laws and regulations. • In clinics and hospitals where the use of wireless devices is prohibited, please comply with the regulations and power off your device.
For more information about where and how to drop off your EEE waste, please contact your local authorities, retailer or household waste disposal service or visit the website http://consumer.huawei.com/en/.
38.52 V/m at 15 cm. Statement Hereby, Huawei Technologies Co., Ltd. declares that this device CP39S is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. The most recent and valid version of the DoC (Declaration of Conformity) can be viewed at http://consumer.huawei.com/certification.
Page 13
For the most recent information about accessories and software, please see the DoC (Declaration of Conformity) at http://consumer.huawei.com/certification. FCC statement Body worn operation This equipment complies with relevant RF radiation exposure limits set forth for a public/uncontrolled environment.
Page 14
(2) this device must accept any interference received, including interference that may cause undesired operation. Caution: Any changes or modifications to this device not expressly approved by Huawei Technologies Co., Ltd. for compliance could void the user's authority to operate the equipment. IC Statement This device complies with CAN ICES-1/NMB-1.