Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Centurion Manuals
  4. PCI Card
  5. Guard
  6. Installation manual

Centurion Guard Installation Manual

Hide thumbs

Advertisement

Quick Links

Download this manual
P C I I n s t a l l a t i o n G u i d e

Advertisement

loading
Need help?

Need help?

Do you have a question about the Guard and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Centurion Guard

  • Page 1 P C I I n s t a l l a t i o n G u i d e...

  • Page 2: Package Components

    PACKAGE COMPONENTS Below is a list of each component included in the package. 1. Floppy Cable 2. Power Cable 3. PCI Board 4. Keys 5. Metal Plate 6. Plastic Face Plate 7. Installation Diskette (Not Shown)

  • Page 3: Hardware Installation

    HARDWARE INSTALLATION Step 1. Insert the plastic key plate into the front panel of the computer case. (Figure 1) Figure 1 Step 2. Insert the metal plate. Locate the keylock hole in the metal plate. (Figure 2) Step 3. Feed the keylock cable through the keylock hole. Snap the front cover into place.
  • Page 4 HARDWARE INSTALLATION CONTINUED Step 4. Attach the power cable to the power connector on the PCI board. (Figure 4) Figure 4 Step 5. Attach the keylock cable to the PCI board as shown in Figure 5. Figure 5...
  • Page 5 Note: Attach the floppy cable so that the center floppy connector is attached to the motherboard. The connector at the “long” end of the cable is attached to the Centurion Guard PCI board, and the other end connector is attached to the floppy disk drive. See Figure 8.5 on the following page.
  • Page 6 HARDWARE INSTALLATION CONTINUED Pin #1 (colored wire) Figure 8.5 Centurion Guard® Floppy Drive Motherboard Step 9. Connect the power cables to the power supply and the DVD Drive as shown in Figures 9, 10, and 11. Connect to Power Supply...

  • Page 7: Software Installation

    SOFTWARE INSTALLATION Begin the Centurion Guard® software installation by setting the com- puter configuration to the default conditions you wish to use. This includes installing any software applications that will be used on the system. Continue by following the steps below: 1.
  • Page 8 SOFTWARE INSTALLATION CONTINUED 5. You will be asked to choose to either protect “All” drives or the current “Active” drive. Choosing Yes will create a storage area on each drive indicated in the “Drive Window.” Selecting No will create a storage area on only the Active drive appearing in the notes area at the bottom of the window.
  • Page 9 SOFTWARE INSTALLATION CONTINUED 7. To apply the fix, select OK. To continue without applying the fix, remove the check mark before selecting OK and confirm that you would like to proceed without applying the fix by again selecting OK on the dialog box below.
  • Page 12 General Notice: Other product names used herein are for identification purposes only and may be trademarks of their respective owners. Centurion Technologies, Inc.™ disclaims any and all rights in those marks. Centurion Technologies, Inc.