Vigoro EcoBorder ECOBRD BRN 4FT Use And Care Manual

Hammer Safety goggles
Installation
Preparing the Area
□
Rake the soil in the space where you are
placing the edging to make it slightly
higher than the flower bed as the ground
will settle over time.
Cutting the Edging (if needed)
WARNING: Wear safety goggles when cutting the edging or
connector rods.
□
If a section smaller than 4 ft. is needed, you can cut the edging
using a handsaw, hacksaw, or an electrical saw. For a more
accurate cut, use a miter box.
□
If using an electric saw, spray the blade lightly with a lubricant as
this will ease the cutting process.
□
If the connector holes need to be deepened or adjusted for any
reason, use a 3/16 in. drill bit to drill 1.5 in. deep holes.
TOOLS REQUIRED
Garden tools
Gloves such as a rake or
Placing the Edging
and Connecting
CAUTION: Wear gloves when installing the
product.
□
Place the edging just inside the edge of the
bed and flush to the lawn.
□
Curve the edging around the flower bed as
desired, ensuring you do not create bends in
excess of 70˚.
□
To add additional edging sections, place the
connector rods (BB) in the holes on the side
by working the edging pieces backward and
forward until the gaps are closed between
the edging sections.
MODEL #ECOBRD BRN 4FT, ECOBRD RED 4FT, ECOBRD BLK 4FT
4 ft. EcoBorder No-Dig Edging
HARDWARE INCLUDED
trowel
BB
ITEM #502-689, 502-784, 1001-632-853
Use and Care Guide
AA - 8 in. Stake x4 BB - 3 in. Connector Rods x2
Staking and Plugging
the Edging
□
Once edging is in the desired position,
install stakes (AA) near where edging
is connected together.
□
After stakes (AA) are installed near the
connections, install the remainder of
the stakes (AA) where desired.
□
Use a hammer to tap down the stakes
(AA) until the top of the stakes are
flush with the edging.
WARNING: Wear safety goggles when
using the hammer to tap down the
stakes.
Please contact 1-877-527-0313 for further assistance.
AA
HOMEDEPOT.COM