Advertisement
Quick Links
Electric Cleaners Trolley
15710355 | 15710355V4 | MK2/400W
Operation Manual
Read and observe all warnings on this unit before operation it.
DO NOT operate this equipment unless all factory installed guards and shields are properly secured.
1300 305 314
sales@backsafeaustralia.com.au
backsafeaustralia.com.au
© BACKSAFE AUSTRALIA
Advertisement
Summary of Contents for BACKSAFE STURGO 15710355
- Page 1 15710355 | 15710355V4 | MK2/400W Operation Manual Read and observe all warnings on this unit before operation it. DO NOT operate this equipment unless all factory installed guards and shields are properly secured. 1300 305 314 sales@backsafeaustralia.com.au backsafeaustralia.com.au © BACKSAFE AUSTRALIA...
- Page 2 Foreword Thank you for purchasing the STURGO® Electric Cleaners Trolley! This manual is about how to operate and maintain machines with model numbers 15710355, 15710355V4, MK2/400W. It is imperative that any person intending to use this machine is fully conversant with the contents of this document.
- Page 3 INDEX Battery Care, ............................8 Fault Finding, ............................8 Operator Maintenance, ........................9 SELF HELP GUIDE, ..........................12 Status Display, ............................7 Technical Maintenance, ........................9 Using the Machine, ..........................4 Warranty, ............................11 60 Mordaunt Circuit, Canning Vale 6155, WA . P: 1300 305 314 . F: 1300 826 188 . www.backsafeaustralia.com.au AUSTRALIA-WIDE | DELIVERY .
-
Page 4: Self Help Guide
Using the Machine 1. Turn ON the switch. The indicator panel will illuminate from 1 to 10 bars indicating the charge status of the battery. If the indicator is flashing or rippling up and down, refer to the SELF HELP GUIDE. Image 1: Functions of the Hand Control Unit 2. - Page 5 3. If driving upwards on a steep slope at low pre-set speed settings, the SPEED SET control may need to be increased to provide sufficient torque to climb the slope. Remember to reset the SPEED SET control when resuming flat ground or downhill use. 4.
- Page 6 7. Provision is made to disconnect the battery pack from the drive system in the event of an emergency or where it is necessary to carry out maintenance. A red connector with pull handle is located on the left side of the battery tray. Pull sharply on the handle disengage the connector.
- Page 7 Status Display The status indicator panel will normally be in the steady condition, indicating battery status (10 lights = battery fully charged, down to 1 light = battery discharged). In the event that the lights on the indicator panel are flashing, an abnormal operating condition or fault is indicated (refer to the SELF HELP GUIDE).
- Page 8 Fault Finding If the status indicator lights are flashing, refer to the SELF HELP GUIDE. Where this does not assist in resolving the difficulty encountered, contact your supplier for assistance. Battery Care The batteries are fully sealed and do not require any maintenance. The batteries must be charged after each period of use, regardless of the battery status indication.
- Page 9 Operator Maintenance 1. Follow charging recommendations to maximise battery life. This information is with the battery charger instructions. (DAILY) 2. Manipulate the brake lever from DRIVE to FREEWHEEL position. If it does not move freely from one position to the other, refer to Technical Maintenance section. (DAILY) 3.
- Page 10 Image 3: Brake maintenance Image 4: Brake oil lubrication diagram 60 Mordaunt Circuit, Canning Vale 6155, WA . P: 1300 305 314 . F: 1300 826 188 . www.backsafeaustralia.com.au AUSTRALIA-WIDE | DELIVERY . SERVICE . PARTS . SUPPORT Page 10 of 13...
- Page 11 Warranty Electric drive system Any failure occurring in normal use over a period of twelve months from the date of purchase will be rectified by repair or replacement of the relevant component, subject to delivery of the faulty machine (or component), to an authorised service centre. This is applicable to the drive system and battery charger.
- Page 12 SELF HELP GUIDE The status lights display battery condition when lights are steady and error codes when lights are flashing on and off. Count the bars lit and check against this list. Low Battery Voltage - The battery needs charging or there is a bad connection to the battery.
- Page 13 In the event that following the self diagnosis chart has not solved your difficulty, please contact your supplier. 60 Mordaunt Circuit, Canning Vale 6155, WA . P: 1300 305 314 . F: 1300 826 188 . www.backsafeaustralia.com.au AUSTRALIA-WIDE | DELIVERY . SERVICE . PARTS . SUPPORT Page 13 of 13...