Table of Contents
Advertisement
WARRANTY AND DISCLAIMER
DIGITAL
MANUFACTURES AGAINST DEFECTS IN MATERIALS AND WORKMANSHIP
FOR A PERIOD LIMITED TO 1 YEAR FROM THE DATE OF SHIPMENT,
PROVIDED THE PRODUCTS HAVE BEEN STORED, HANDLED, INSTALLED,
AND USED UNDER PROPER CONDITIONS.
The company's liability under this limited warranty shall extend only to the
repair or replacement of a defective product, at the company's option. DIGITAL DELAY
INC. disclaims all liability for any affirmation, promise, or representation with respect to
the products.
The customer agrees to hold DIGITAL DELAY INCORPORATED harmless
from, defend, and indemnify DIGITAL DELAY INC. against damages, claims, and
expenses arising out of subsequent sales of or use of DIGITAL DELAY INC. products, or
products containing components manufactured by DIGITAL DELAY INC. and based
upon personal injuries, deaths, property damage, lost profits, and other matters which
BUYER, its employees, or sub-contractors are or may be to any extent liable, including
without limitation, penalties imposed by the Consumer Product Safety Act (P.L. 92-573)
and liability imposed upon any person pursuant to the Magnuson-Moss Warranty Act (P.L.
93-637), as now in effect or as amended hereafter.
No warranties expressed or implied, are created with respect to the company's
products except those expressly contained herein.
disclaimers and limitations contained and relies on no other warranties or affirmations.
MEGA 350/450
DELAY
INC.
WARRANTS
THE
The customer acknowledges the
1
PRODUCTS
IT
Advertisement
Table of Contents
Need help?
Do you have a question about the MEGA 350 and is the answer not in the manual?
Questions and answers
When I turn on my ignition switch the air shift will not release so that I can pull the shifter into another gear, what would cause this?
If the air shift does not release on a BIONDO MEGA 350 when the ignition switch is turned on, possible causes include:
1. The shifter is not moving when the mode changes state.
2. The Shift terminal does not have 12 volts when Shift Output Mode is set to LO.
3. The Shift terminal wiring is incorrect or disconnected.
4. The button connected to the P.B. 1 terminal is not functioning or wired correctly.
5. The pushbutton or its wiring is faulty, preventing the “Transbrake On” signal from displaying.
These issues can prevent proper signal output to activate the air shifter.
This answer is automatically generated