AmmoAudio Ammo Can X Instruction Sheet

First off, congratulations on your purchase of the best rugged Bluetooth speaker in the world! This instruction sheet is a
quick review of how to use your Ammo Audio device to make sure you get the most out of it.

Playing Music

Bluetooth

You can wirelessly stream music from your smartphone or other device to
the Ammo Can X via Bluetooth 4.0 by simply toggling the blue missile
switch with the Master switch ON. The switch will illuminate and the
speaker will play a short tone sequence indicating that the Bluetooth
module is active. If you plan to use the speaker with the lid open, flip the
antenna up, otherwise leave it in the folded position*. The Bluetooth
range is approximately 50 feet with the lid open and 15 feet with the lid
closed, although it can vary depending on what kind of device you are
streaming from (smartphones tend to do better than tablets).
If this is the first time you are pairing your device to the Ammo Can X, pull
up the Bluetooth screen in your settings and hit scan if required. Your
device will list all the active Bluetooth devices within range. Once
"AmmoAudio" appears, tap on it to pair the Ammo Can X with your device.
After a few seconds you will hear a short beep from your speaker
indicating that pairing is complete. You are ready to rock!
If you have already paired the speaker with your device, it should
automatically connect whenever you toggle the Bluetooth switch on the
Ammo Can X.
*Due to space limitations, your Ammo Can X may have been shipped with
the Bluetooth antenna removed. If this is the case, simply thread it onto
the gold SMA connector until it is finger tight. Don't worry! You won't
have to remove the antenna again unless you want to, as the lid can be
closed with the antenna in the folded position.

Aux Input

The AUX port is another way to connect your device to the Ammo Can X if you do not have Bluetooth functionality and/or
prefer not to use Bluetooth. Since Bluetooth is a "lossy" compression, plugging the source directly into to amp via a
Ammo Can X Instruction Sheet

Power

To power up the Ammo Can X, lift up the red cover on the missile switch labeled
"MASTER" and toggle the switch forward. After a short delay (about 1 second),
the switch will illuminate indicating that your speaker is powered up and ready
for action. This is the main power switch, which brings power from the battery
through the fuse to power up the amplifier, and enable the Bluetooth and USB
charger switches.
AMMOCAN X INSTRUCTIONS, VERSION 5 1