VIKING BAGS UNIVERSAL LARGE PLAIN SINGLE STRAP SADDLEBAGS Installation Instructions

VIKING UNIVERSAL LARGE PLAIN SINGLE STRAP SADDLEBAGS INSTRUCTION
Step 1
1. Assemble the
support (See Figure C).
2. Make Sure it is securely mounted
on the bike (See Figure C).
Fig.C
Step 4
When you have the yoke in the
correct position, tighten the nylon
safety strap using the adjustable D-
rings (See Figure C) on the top of the
yoke.
Fig.C
888-208-1949 |
saddlebags Lift the back seat and install the bags
on your bike. Your saddlebags must
be at least 1 inch clear of any
exhaust pipe, while stationary or
moving.
Fig.A
Saddlebags are adjustable towards
the front/rear of the bike for clearing
turn signals and shock absorbers
(See Figure D). Use appropriate pair
of holes to adjust the mounting
position of the saddlebags.
Fig.D
copyright © 2016 Vikingbags
www.vikingbags.com
support@vikingbags.com
Step 2
Step 5
Step 3
For height adjustment of the bags,
separate the two yoke halves and
reposition them. Adjust the yoke
shorter for higher saddlebags, and
vice versa. (See Figure B).
Fig.B
Step 6
Use the straps located at the bottom
of each bag (Fig E) to connect the
bag to the saddlebag support. Wrap
them around the support, buckle the
ends together, then adjust the length
so that the straps are tight and are
held securely in a fixed position.
Fig.E