HSS Hire 56726 Operating & Safety Manual

To change filters, with a 3/8" wrench, loosen the 8
latches holding the inlet panel in place.
Slide the latches outward, away from the center of the
inlet panel.
Remove the inlet panel and replace used filters.
change filter light
pre-filter
latches

MULTI-POSITIONAL

You can stack and operate up to two Air
Scrubbers vertically. The handle of one unit
fits into bottom of another unit. You can also
stack them horizontally for space-saving
storage, or operate a unit with its outlet
facing upward.

EQUIPMENT CARE

Never push the equipment beyond its design limits. If it
will not do what you want with reasonable ease and speed,
assume you have the wrong equipment for the job. Contact
HSS Hire for advice.
Keep the equipment clean - you will find this less of a
chore if you clean it regularly, rather than wait until the end
of the hire period.
Always after job replace the filters.
When not in use, store the equipment somewhere
clean, dry and secure.

FINISHING OFF

Turn the unit OFF before unplugging the unit.
Unplug the unit, and neatly coil the flex. Remove the
filters and give the unit a final clean up ready for return,
to HSS Hire.
filter
... have you been trained
The law requires that personnel using this type of equipment in
the workplace must be competent and qualified to do so.
Training is available at HSS Training
...any comments?
If you have any suggestions to enable us to improve the
information within this guide please e-mail your comments or
write to the Safety Guide Manager at the address below
e-mail: safety@hss.com
©HSS Hire Service Group Ltd 2011 No. 743/01
Group Office: 25 Willow Lane, Mitcham, Surrey CR4 4TS
Web Site: http://www.hss.com
0845 766 7799
Operating & Safety Guide 743 Operating & Safety Guide 743
Air Scrubber
Air Scrubber
Portable filtration unit capable of
removing airborne particles like dust,
mould spores, pollen. Ideal for
restoration work.
Code 56726
743/01 743/01