Weather Guard EZ-GLIDE 2501 Instruction And Repair Parts Manual

Warning light holder

Read and understand all instructions and warnings before operating or using this product.

This product is only intended and only safe for transporting ladders. It is the responsibility of the user to secure these

materials to the rack before transporting.

Ladders must be secured per ANSI standard A142.2-1990 paragraph 8.4.4. Ladder damage will occur from road shock

and vehicle vibration if the ladder is not properly secured to the ladder rack. Bouncing and side to side motion of an

improperly secured ladder will cause wear and weaken the ladder. Using a damaged ladder could lead to structural col-

lapse resulting in serious injury or death. Place ladder in a raised position before transporting. Driving with rack in lowered

position may cause serious injury or damage to vehicle, ladder, rack or persons.

Any modification or unintended use of this product shall immediately void all manufacturers warranties. Manufacturer dis-

claims all liability for injuries to persons or property resulting from any modification to, or unintended use of this product.

Never load your rack to exceed the safe capacity of your vehicle. Heavy loads when carried high can dangerously alter the

center of gravity.

Loads should be approximately centered front to rear. Failure to do this will cause damage to the vehicle roof. Long loads

that extend out the rear of the vehicle will prevent the rear hatch from fully opening and cause damage if attempted.

TOOLS REQUIRED

•

1/2" Open or Box End Wrench

• 3/8" Drive Socket (1/2")

• 3/8" Drive Ratchet

• 3/8" & 1/2" Drill Bits

• Electric Drill

• Tape Measure

PARTS LIST

•

Warning Light Holder

MODEL

–ATTENTION–

WARNING

–NOTICE–

CAUTION

ASSEMBLY INSTRUCTIONS

Approximate assembly and Installation time:

30 min. per unit (1/2 hr.) depending on van equipment and installer experience.

IMPORTANT BEFORE YOU BEGIN

Read these instructions and warnings completely before installation.

Check this kit to be sure the following parts are included.

2501 EZ-GLIDE

™

WARNING LIGHT HOLDER

HARDWARE KIT

SEE PAGE 2

Mounting Kit:

5/16-18 x 2-3/4" Hex Hd. Bolt

5/16-18 Nylon Lock Nut

5/16" Flat Washer

Part No. 24-0105 REV. C ECN 5315 05/13

SYSTEM

Table of Contents

Need help?

Do you have a question about the EZ-GLIDE 2501 and is the answer not in the manual?

Questions and answers

Summary of Contents for Weather Guard EZ-GLIDE 2501

Page 1 MODEL 2501 EZ-GLIDE SYSTEM ™ WARNING LIGHT HOLDER –ATTENTION– Read and understand all instructions and warnings before operating or using this product. WARNING This product is only intended and only safe for transporting ladders. It is the responsibility of the user to secure these materials to the rack before transporting.
Page 2 PERIOD OF TWO (2) YEARS FROM DATE OF PURCHASE BY THE ORIGINAL RETAIL PURCHASER. If, before the expiration of the Warranty period, purchaser discovers that the KNAACK or WEATHER GUARD product fails to fulfill the Warranty, purchaser shall contact Knaack LLC to make arrangements for an inspection of the product. If Knaack LLC determines a defect exists, Knaack LLC shall, at its option and expense, repair or replace any defective part.