Related Manuals for Satel INT-SZK
Summary of Contents for Satel INT-SZK
- Page 1 INT-SZK Code lock Firmware version 2.02 int-szk_en 08/20 SATEL sp. z o.o. • ul. Budowlanych 66 • 80-298 Gdańsk • POLAND tel. +48 58 320 94 00 www.satel.eu...
- Page 2 Changes, modifications or repairs not authorized by the manufacturer shall void your rights under the warranty. SATEL aims to continually improve the quality of its products, which may result in changes in their technical specifications and software. Current information about the changes being introduced is available on our website.
-
Page 3: Table Of Contents
CONTENTS Features ........................... 2 Installation ........................2 Address setting ......................3 Description of terminals ....................4 Configuring ........................4 Description of parameters and options ............... 4 Using ..........................7 LED indicators ......................7 Sound signaling ......................7 4.2.1 Beeps generated when operating ................ 7 4.2.2 Signaling events .................... -
Page 4: Features
INT-SZK SATEL The INT-SZK code lock can control the access to a single door. The device can be used in conjunction with the INTEGRA and INTEGRA Plus control panels. Fig. 1. INT-SZK code lock with closed and open flap cover. -
Page 5: Address Setting
SATEL INT-SZK 4. Drill the holes for wall plugs (anchors). 5. Run the wires through the opening in the enclosure base. 6. Using wall plugs (anchors) and screws, fasten the enclosure base to the wall. Select wall plugs specifically intended for the mounting surface (different for concrete or brick wall, different for drywall, etc.). -
Page 6: Description Of Terminals
INT-SZK SATEL Switch (ON position) Number Table 1. Fig. 3. Examples of code lock address setting. 2.2 Description of terminals - relay output - door status input (NC) COM - common ground +12V - power input DTA - data (expander communication bus) CLK - clock (expander communication bus) 3. - Page 7 SATEL INT-SZK Relay ON time – the time during which the relay output can be turned on after the access is granted. You can program from 1 to 255 seconds. Relay [Relay type] – status of the deactivated relay: NO [Normal.open NO] – the relay contacts are open (they close on activating the relay).
- Page 8 INT-SZK SATEL Confirmation – method of providing feedback to the user after using the code lock: No – no feedback. Sound – the code lock will use sounds to give feedback to the user. Backlight – the code lock will use key backlight to give feedback to the user.
-
Page 9: Using
SATEL INT-SZK Auto-backlight – if the keys backlight comes on automatically, you can additionally define whether and what event will turn the backlight on: No – the keys backlight will not be additionally turned on. Zone violation – the keys backlight will additionally go on if a selected zone is violated. -
Page 10: Code
INT-SZK SATEL 4.3 Code Most of the functions are available after entering the code. By factory default, the following codes are programmed in the control panel: service code: 12345 object 1 master user (administrator) code: 1111 The factory default codes should be changed before you start using your alarm system Do not make your code available to other people. - Page 11 SATEL INT-SZK Operating temperature range ................-10°C...+55°C Maximum humidity ......................93±3% Dimensions ....................144 x 80 x 27 mm Weight ..........................160 g...
Need help?
Do you have a question about the INT-SZK and is the answer not in the manual?
Questions and answers