Table of Contents
Advertisement
Quick Links
iZ2EM Smart Energy In Wall Meter
Fig 2. Assembling
TM
This dual meter module is a transceiver which is a Z-Wave
enabled device and is
TM
fully compatible with any Z-Wave
enabled network. This product can be included
and operated in any Z-Wave network with other Z-Wave certified devices from other
manufacturers and/or other applications. And it can act as repeaters within the
network regardless of vendor to increase reliability of the network.
Mini size design let the module can easily hide itself into the electricity distribution
box and that will be good for the house decoration.
This dual meter module is able to detect Instant power wattage (13800W/230Vac)(60
Amperes) of connected light or appliances.
Fig 1. Assembling
TM
Adding to Z-Wave
Network
In the front casing, there is an on/off button with LED indicator below which is used to
carry out inclusion, exclusion, reset or association. After being excluded, its LED
flashes on and off alternately and repeatedly at 2-second intervals. It implies that it
has not been assigned a node ID and cannot work with Z-Wave enabled devices.
www.mordomus.com
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for MORDOMUS iZ2EM
Summary of Contents for MORDOMUS iZ2EM
- Page 1 Smart Energy In Wall Meter Fig 2. Assembling This dual meter module is a transceiver which is a Z-Wave enabled device and is fully compatible with any Z-Wave enabled network. This product can be included and operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers and/or other applications.
- Page 2 1. Put your Z-Wave controller into One press one flash LED intervals. exclusion mode by following the When iZ2EM is in learning mode, LED flashes on and off alternately instructions provided by the controller Learning manufacturer. and repeatedly at 0.5 second intervals.
- Page 3 922~927MHz (Taiwan/JP) ** Specifications are subject to change and improvement without notice. 1. Put the meter into a wall box and connect the AC power wire L,N to iZ2EM connector L, N. 2. The black wire of current sensor, CT1 or CT2, should connected to the negative terminal of iZ2EM,CT1- or CT2-.
- Page 4 These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. www.mordomus.com...
Need help?
Do you have a question about the iZ2EM and is the answer not in the manual?
Questions and answers