Summary of Contents for ACCO Brands Quartet InvisaMount Glass Board
- Page 1 Quartet InvisaMount Glass Boards 7/32” ACCO Brands (Returns Center) 101 Bolton Ave 9E Booneville, MS 38829 USA Tel: 800-541-0094 www.acco.com...
- Page 2 Quartet InvisaMount Glass Boards 7/32” ACCO Brands (Returns Center) 101 Bolton Ave 9E Booneville, MS 38829 USA Tel: 800-541-0094 www.acco.com...
- Page 3 Quartet InvisaMount Glass Boards What’s Included in the Hardware Kit? Paper Installation Template Wall Mount Brackets Self-Drilling Drywall Anchors Phillips Head Screws InvisaMount Glass Board Accessory Tray What Else Do I Need? Tape - make sure it's safe for the wall Push Pin Phillips Head Screwdriver Level...
- Page 4 Step 2 – Mark the Wall Locate the “Push tack here” spots at the top and bottom of the template. Use a push pin to mark these spots. Remove the push pin. Steps 3 – Remove the Template Carefully remove the Paper Installation Template from the wall.
- Page 5 Step 5 – Mount Wall Brackets Find the center hole on the Wall Mount Bracket (Part B) and place it over the top anchor, with the holes toward the bottom of the bracket. Use a screwdriver to insert a screw through the Wall Mount Bracket and into the anchor.
- Page 6 Step 9 – Insert Remaining Anchors Use a 7/32” drill bit to create pilot holes. 7/32” Insert a Self-Drilling Drywall Anchor (Part C) into each mark using a screwdriver. Turn clockwise until the head of the anchor is ush with the wall. Steps 10 and 11 –...
- Page 7 Step 13 – Place Board on the Brackets Lift your InvisaMount Glass Dry-Erase Board against the wall, slightly higher that the Wall Mount Brackets. Once lined up, slide the glass board down until the attached mounting clips slide into place behind the Wall Mount Brackets. Note: Clips should slide in at the same time for both the top and bottom Wall Mount Brackets.
Need help?
Do you have a question about the Quartet InvisaMount Glass Board and is the answer not in the manual?
Questions and answers