Signal Words; Safety Instructions - Vestil SBM Series Instruction Manual

Economy spreader beams
Table of Contents

Advertisement

Table of Contents

SIGNAL WORDS

This manual uses SIGNAL WORDS to draw attention to uses of the product that could result in
personal injuries, as well as the probable seriousness of those injuries. Other signal words call attention
to uses likely to cause property damage. Signal words used in this manual appear below along with the
definition of each word.
Identifies a hazardous situation which, if not avoided, WILL result in DEATH or
SERIOUS INJURY. Use of this signal word is limited to the most extreme situations.
Identifies a hazardous situation which, if not avoided, COULD result in DEATH or
SERIOUS INJURY.
Identifies practices likely to result in product/property damage, such as operation that
might damage the product.

SAFETY INSTRUCTIONS

Vestil strives to identify all foreseeable hazards associated with the use of its products. However,
material handling is dangerous and no manual can address every conceivable risk. Ultimately, the most
effective way to prevent injury is to apply sound judgment whenever using this device.
Material handling is dangerous and could result in serious personal injuries or death.
Read and understand the entire manual before using or servicing this lifter. DO NOT use this
device until you read and understand the entire instruction manual. Read the manual to refresh your
understanding of proper use and maintenance procedures.
This lifting device must only be used by designated persons and lifting device inspectors. Maintenance
and test personnel should only use this device when necessary to perform their duties.
DO NOT use this lifter if it is damaged, malfunctioning, or missing parts.
DO NOT modify the product in any way without first obtaining written approval from Vestil. Unapproved
modifications automatically void the
Only attach the lifter to a properly functioning safety hook, i.e. a hook with a spring latch.
DO NOT remove or obscure any label. Confirm the placement and legibility of all labels as shown in the
LABELING DIAGRAM
Inspect the lifter before each use. See
Review safety messages in the manuals for your crane, trolley, hoist, rigging, and all other devices used
in conjunction with this spreader beam
Tighten the shackle pins before each use. See "Hook with Shackle" in Exploded Views on
Make sure your travel path is clear before picking up a load.
• DO NOT use this lifter to move a load item if the item does not balance when it is elevated. The beam
should be horizontal/level when the load is elevated.
• DO NOT lift more than 1 item at a time.
• DO NOT lift people. This device must only be used to lift materials.
• Center the hoist above the load item before connecting it to a load. Centering minimizes load swing as
the load lifts off of the ground. DO NOT side load the hoist/lifter.
• DO NOT sit, or ride, on the load item or the lifter.
• DO NOT exceed the rated load/capacity of your lifter. Capacity figures are provided in
tables on
p.
4, 5, 6, and 7, as well as on product labeling. See
• Carefully eliminate slack in the hoist line and rigging before raising the load. Lift and lower loads slowly
and steadily. Avoid jolting the loads.
• Slowly raise the loaded lifter a few inches above the ground to determine whether the load is stable.
• DO NOT lift a load higher than necessary. See
close to the ground as possible while moving it and avoid obstructions.
• Avoid contact with the load item while it is suspended. DO NOT get in front of or behind a suspended
load. Avoid putting your feet and other parts of your body beneath the load item. NEVER lift material over
yourself or other people.
• Watch the load carefully while lifting and moving it. The load could swing or spin while elevated.
Table of Contents
LIMITED WARRANTY
on p. 9. DO NOT use this device UNLESS all labeling is readable and undamaged.
INSPECTIONS AND MAINTENANCE
.
Copyright 2017 Vestil Manufacturing Co.
Rev. 2/21/2020
and might make the product unsafe to use.
LABELING DIAGRAM
on p. 8. Keep the suspended load as
USING THE LIFTER
SBM MANUAL
on p. 9.
p.
4, 5, 6, & 7.
SPECIFICATIONS
on p. 9.
Page 2 of 10

Advertisement

Table of Contents
loading

Table of Contents