1. Manuals
  2. Brands
  3. U.S.T.E. Manuals
  4. Underwater lighting
  5. Vista 4217
  6. Installation instructions

U.S.T.E. Vista 4217 Installation Instructions

Underwater light
Hide thumbs
1
2

Advertisement

Table of Contents

UNDERWATER LIGHT
MODEL #4217
FOR USE ONLY WITH LOW VOLTAGE LANDSCAPE POWER UNITS THAT DO NOT
EXCEED 25 AMPS, 15 VOLT MAX.
WARNING: Luminaire must be installed in accordance with the National
Electrical Code (NEC) and local codes. Failure to do so will void the warranty
and may result in serious injury and/or damage to the luminaire.
SAFETY WARNING: Luminaire can become very hot depending on lamp wattage used.
Lens and metal around lamp can become hot enough to blister hands. Particular care
should be taken not to locate luminaires where small children can reach them if high
wattage lamps are used.
LUMINAIRES ARE NOT TO BE INSTALLED WITHIN 10 FT. (3.05M) OF A
POOL OR SPA. SECONDARY CABLE IS NOT TO BE BURIED MORE THAN
6". WHEN USING MULTIPLE LUMINAIRES, LOAD IS NOT TO EXCEED
TOTAL WATTS OF TRANSFORMER RATING. DO NOT USE EXTENSION
CORDS ON POWER UNITS.
NOTE: Always use UL recognized wire connectors for connections.
NOTE: Save these instructions for future reference.

TOOLS REQUIRED FOR INSTALLATION:

Phillips head screwdriver
Wire strippers
Silicone grease
CAUTION!!: THIS LUMINAIRE IS INTENDED FOR USE IN WATER GARDENS AND PONDS
ONLY. NOT FOR USE IN SWIMMING POOL OR SPA APPLICATIONS.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Vista 4217 and is the answer not in the manual?

Questions and answers

Summary of Contents for U.S.T.E. Vista 4217

  • Page 1 INSTALLATION INSTRUCTIONS FOR 12 VOLT UNDERWATER LIGHT MODEL #4217 FOR USE ONLY WITH LOW VOLTAGE LANDSCAPE POWER UNITS THAT DO NOT EXCEED 25 AMPS, 15 VOLT MAX. WARNING: Luminaire must be installed in accordance with the National Electrical Code (NEC) and local codes. Failure to do so will void the warranty and may result in serious injury and/or damage to the luminaire.
  • Page 2 1. To prevent electrical shock, disconnect transformer from electrical supply before installation or service. NOTE: DO NOT pull the underwater cable. If wire is pulled, it may break the liquid tight seal and void the warranty. NOTE: DO NOT loosen or remove the liquid tight connector. This will damage the factory set seal and result in possible leakage.

Table of Contents