Advertisement
Assemble your fountain on a level surface capable of holding a minimum of 343 pounds with an approximate 2 square
foot footprint.
FT-73C (188 lbs)
27"L x 18"W x 8.25"H
FT-73B (12 lbs)
5.5"L x 7.25"W x 5.5"H
FT-73A (90 lbs)
16"L x 16"W x 12"H
FT-73BB (2 lbs)
4.5"L x 1.25"W x 3.75"H
FT-73 Genesis II Fountain
Two people are recommended for the installation of this fountain!
1. Position the basin (FT-73C) where the fountain is to be installed, ensuring
that it is level.
2. Assemble the fountain plumbing
a.
b.
3. Feed the pump cord all the way through the hole in the basin and run the
cord through the channel in the bottom to ensure the fountain will be level.
4. FIRMLY press the stopper into the hole evenly.
a. Note: Using the handle of a screwdriver or hammer works best to
5. Place the pump cover (FT-73B) over the pump. Ensure it is placed properly
and leveled.
6. Position the water feature (FT-73A) over the pump cover.
7. Secure the loose end of the non-kink tubing to the pipe protruding from the
bottom of the water feature (FT-73A).
8. Ensure the water feature is centered and leveled on the pump cover.
9. Place the pump cover door (FT-73BB) in the pump access opening of the
pump cover.
10. Fill the fountain with water.
Using a hose clamp, attach the 1/2" non-kink tubing to the pump outlet.
Place the stopper around the pump cord approximately 6" from the pump.
press the stopper in place.
Revised March 31, 2017
Advertisement
