Advertisement
Installation
1. Place the Mini incubator on a clean, level, and
stable surface.
2. remove the power supply from the white box
inside the chamber and plug the wall end into
the wall outlet.
3. Plug the other end of the power supply into
the 2–pin inlet (top inlet) labeled Dc on the
backside of the unit.
4. Press the power key on the front display.
Operation
to select the desired temperature, press the
the display begins to flash and then the
be used to choose the desired temperature. once the desired
temperature has been selected, the display stops flashing and
the chamber begins to heat or cool accordingly.
When loading samples, always avoid placing samples directly
NOTE
in front of fan vents. This will minimize airflow and diminish
temperature performance.
the Mini incubator is also equipped with an internal light to
assist in viewing.
to activate the internal light, press the Light button
to turn off the internal light, press the Light button again.
Internal Outlet
to use the internal outlet, plug the included power cable into
the bottom power inlet on the backside of the Mini Digital
incubator. the internal outlet is now powered.
The voltage of this internal outlet is dependent on the wall
voltage. (If the wall voltage is 230V, the voltage of the
NOTE
internal outlet is also 230V.)
Digital Mini incubator
Figure 1
DC Top Inlet
and
key.
and
keys can
| uSEr'S guiDE
5
Advertisement
