Advertisement
6.
tRouBLEShootING
PRoBLEM
PoSSIBLE CAuSE
Beam will not lift the load
1) overloaded
2) oil level low
3) release valve not correctly closed
4) Air in system
5) Piston rod not functioning
6) Packing worn or defective
Beam does not lift high
1) oil level too high or too low
enough or feels "spongy"
2) Worn seals
3) Air in system
4) release valve not closed
1) Pump packing or valves malfunctioning
Beam lifts poorly
2) oil is dirty
3) Air in the system
Beam lifts but will not hold load
1) release valve partially open
2) dirt on valve seats
3) Air in system
4) Faulty seals
5) Packing worn or defective
Beam will not lower completely
1) unit requires lubrication
2) Piston rod bent or damaged
3) Beam frame/link system distorted due
4) Air in system
5) release valve partially closed
Beam does not lower at all
1) release valve closed
NoTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPoRtANt: No liability is accepted for incorrect use of this product.
WARRANty: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INfoRMAtIoN: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
to overloading/poor positioning
Sole uK distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7Ar
REMEdy
1) Be sure to use beam with adequate capacity.
2) top up oil level.
3) check and close release valve.
4) open release valve and pump the handle a few times. close valve and re-try.
5) clean and replace oil.
6) replace packing.
1) Fill or remove excess oil.
2) return jack to local service agent.
3) open release valve and pump the handle a few times. close valve and re-try.
4) check and close release valve.
1) replace packing and/or clean valves.
2) replace oil.
3) open release valve and pump the handle a few times. close valve and re-try.
1) check and close release valve.
2) lower jack, close release valve. Place foot on front wheel and pull up lifting arm to full height
by hand. open the release valve to lower arm.
3) open release valve and pump the handle a few times. close valve and re-try.
4) replace packing or contact local service agent.
5) replace packing.
1) oil all external moving parts.
2) replace rod or contact local service agent.
3) replace damaged parts or contact local service agent.
4) open release valve and pump the handle a few times. close valve and re-try.
5) check and fully open release valve.
1) check and fully open release valve.
Original Language Version
www.sealey.co.uk
01284 757500
Web
sales@sealey.co.uk
01284 703534
email
SJBEX200.V2, SJBEX300
fig.4
Issue: 4 - 16/10/09
Advertisement
